Mechanical and transport properties were assessed on wheat gluten films with a glycerol content of 25-40%, prepared by compression molding for 5-15 min at temperatures between 90 and 130 degrees C. Effects of storing the films up to 24 days, in 0 and 50% relative humidity (RH), were assessed by tensile measurements. The films were analyzed with respect to methanol zero-concentration diffusivity, oxygen permeability (OP), water vapor permeability (WVP), Cobb60 and sodium dodecyl sulfate (SDS) solubility coupled with sonication. The SDS solubility and methanol diffusivity were lower at the higher molding temperature. Higher glycerol content resulted in higher OP (90-95% RH), WVP, and Cobb60 values, due to the plasticizing and hygroscopic effects. Higher glycerol contents gave a lower fracture stress, lower Young's modulus, lower fracture strain, and less strain hardening. The mold time had less effect on the mechanical properties than mold temperature and glycerol content. The fracture stress and Young's modulus increased and the fracture strain decreased with decreasing moisture content.

No abstract

No abstract

No abstract

The tensile and stress‐relaxation properties of an uncrosslinked and a loosely silane‐crosslinked high‐density polyethylene exposed to organic “crude‐oil” penetrants were assessed. The measurements were performed on penetrant‐saturated samples, surrounded by the organic liquid throughout the experiment. The penetrant solubilities in the two polymers were similar and in accordance with predicted values based on the solubility parameter method. The stiffness and strength of the swollen samples were significantly less than those of the dry samples, indicating a plasticization of the amorphous component. Raman spectroscopy on polyethylene exposed to deuterated n‐hexane revealed a penetrant‐induced partial melting/dissolution of the crystal surface and an intact crystal core component. The stress‐relaxation rates, within the time frame of the experiment (∼1 s to 18 h), were approximately the same, independent of silane‐crosslinks and the presence of penetrants. This indicated that the mechanical α‐relaxation, which is the main relaxation process occurring in the measured time interval, was not affected by the penetrants. Consequently, its rate seemed to be independent of the crystal surface dissolution (decrease in the content of crystal‐core interface). The shape of the “log stress–log time” curves of the swollen samples was, however, different from that of the dry samples. This was most likely attributed to a time‐dependent saturation of penetrant to a higher level associated with the stretched state of the polymer sample. The silane crosslinks affected only the elongation at break, which was less than that of the uncrosslinked material. © 2005 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 641–648, 2006

No abstract

No abstract

No abstract