Mechanical properties of high‐density polyethylene and crosslinked high‐density polyethylene in crude oil and its components

Abstract

The tensile and stress‐relaxation properties of an uncrosslinked and a loosely silane‐crosslinked high‐density polyethylene exposed to organic “crude‐oil” penetrants were assessed. The measurements were performed on penetrant‐saturated samples, surrounded by the organic liquid throughout the experiment. The penetrant solubilities in the two polymers were similar and in accordance with predicted values based on the solubility parameter method. The stiffness and strength of the swollen samples were significantly less than those of the dry samples, indicating a plasticization of the amorphous component. Raman spectroscopy on polyethylene exposed to deuterated n‐hexane revealed a penetrant‐induced partial melting/dissolution of the crystal surface and an intact crystal core component. The stress‐relaxation rates, within the time frame of the experiment (∼1 s to 18 h), were approximately the same, independent of silane‐crosslinks and the presence of penetrants. This indicated that the mechanical α‐relaxation, which is the main relaxation process occurring in the measured time interval, was not affected by the penetrants. Consequently, its rate seemed to be independent of the crystal surface dissolution (decrease in the content of crystal‐core interface). The shape of the “log stress–log time” curves of the swollen samples was, however, different from that of the dry samples. This was most likely attributed to a time‐dependent saturation of penetrant to a higher level associated with the stretched state of the polymer sample. The silane crosslinks affected only the elongation at break, which was less than that of the uncrosslinked material. © 2005 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 641–648, 2006

Permeation of hydrocarbons through organosilane crosslinked LDPE

“…39 Organosilane crosslinked LDPE material is therefore not applicable as barrier polymer compared to the neat PE against the permeation of small hydrocarbons such as n-pentane and toluene. These results were attributed to the presence of organosilanes in the crosslinked PE.…”

The effects of e‐beam crosslinking of LDPE on the permeation of hydrocarbons

“…2 But also low-density polyethylene (LDPE) is a commonly used material in oil applications. 2 However, in many applications it must be considered that polyethylene is permeable to gases and liquids. 3 To improve the permeation properties of the polymer, a surface modification by sulfonation or fluorination has been demonstrated.…”

“…Rotationally molded fuel tanks are made of LDPE or crosslinked polyethylene. 2,11 Also in the food industry permeation plays a decisive role regarding the packaging of the groceries. 4 Polyethylene is a thermoplastic material and will lose critical physical properties at elevated temperatures.…”

Porous crosslinked copolymers of octadecyl acrylate with acrylic acid as sorbers for crude petroleum spills

“…The nature of swelling processes has been studied . Our objectives are largely practical, namely mitigating the drawbacks named above and achieving higher absorption capacities.…”