The construction, measurement, and modeling of an artificial cochlea (ACochlea) are presented in this paper. An artificial basilar membrane (ABM) was made by depositing discrete Cu beams on a piezomembrane substrate. Rather than two fluid channels, as in the mammalian cochlea, a single fluid channel was implemented on one side of the ABM, facilitating the use of a laser to detect the ABM vibration on the other side. Measurements were performed on both the ABM and the ACochlea. The measurement results on the ABM show that the longitudinal coupling on the ABM is very strong. Reduced longitudinal coupling was achieved by cutting the membrane between adjacent beams using a laser. The measured results from the ACochlea with a laser-cut ABM demonstrate cochlear-like features, including traveling waves, sharp high-frequency rolloffs, and place-specific frequency selectivity. Companion computational models of the mechanical devices were formulated and implemented using a circuit simulator. Experimental data were compared with simulation results. The simulation results from the computational models of the ABM and the ACochlea are similar to their experimental counterparts.

The lack of baleen whale (Cetacea Mysticeti) audiograms impedes the assessment of the impacts of anthropogenic noise on these animals. Estimates of audiograms, which are difficult to obtain behaviorally or electrophysiologically for baleen whales, can be made by simulating the audiogram as a series of components representing the outer, middle, and inner ear (Rosowski, 1991;Ruggero and Temchin, 2002). The middle-ear portion of the system can be represented by the middle-ear transfer function (METF), a measure of the transmission of acoustic energy from the external ear to the cochlea. An anatomically accurate finite element model of the minke whale (Balaenoptera acutorostrata) middle ear was developed to predict the METF for a mysticete species. The elastic moduli of the auditory ossicles were measured by using nanoindentation. Other mechanical properties were estimated from experimental stiffness measurements or from published values. The METF predicted a best frequency range between approximately 30 Hz and 7.5 kHz or between 100 Hz and 25 kHz depending on stimulation location. Parametric analysis found that the most sensitive parameters are the elastic moduli of the glove finger and joints and the Rayleigh damping stiffness coefficient b. The predicted hearing range matches well with the vocalization range.

No abstract

No abstract

At present, there are no direct measures of hearing for any baleen whale (Mysticeti). The most viable alternative to approaches to simulate the audiogram is through modeling outer, middle, and inner ear functions based on the anatomy and material properties of each component. This paper describes a finite element model of the middle ear for the humpback whale () to calculate the middle ear transfer function (METF) to determine acoustic energy transmission to the cochlea. The model was developed based on high resolution computed tomography imaging and direct anatomical measurements of the middle ear components for this mysticete species. Mechanical properties for the middle ear tissues were determined from experimental measurements and published values. The METF for the humpback whale predicted a better frequency range between approximately 15 Hz and 3 kHz or between 200 Hz and 9 kHz based on two potential stimulation locations. Experimental measures of the ossicular chain, tympanic membrane, and tympanic bone velocities showed frequency response characteristics consistent with the model. The predicted best sensitivity hearing ranges match well with known vocalizations of this species.