The objective of this study was to compare the prediction efficiency of IgG concentration in bovine colostrum by NIRS, using liquid and dried (Dry-Extract Spectroscopy for Infrared Reflectance, DESIR) samples by transflectance and reflectance modes, respectively. Colostrum samples (157), obtained from 2 commercial Holstein dairy farms, were collected within the first hour after calving and kept at -20 °C until analysis. After thawing and homogenisation, a subsample of 500 mg of liquid colostrum was placed in an aluminium mirror transflectance cell (0·1 mm path length), in duplicate, to collect the spectrum. A glass fiber filter disc was infused with another subsample of 500 mg of colostrum, in duplicate, and dried in a forced-air oven at 60 °C for 20 min. The samples were placed in cells for dry samples to collect the spectra. The spectra in the VIS-NIR region (400-2500 nm) were obtained with a NIRSystems 6500 monochromator. Mathematical treatments, scatter correction treatments and number of cross-validation groups were tested to obtain prediction equations for both techniques. Reference analysis for IgG content was performed by radial immunodiffusion. The DESIR technique showed a higher variation in the spectral regions associated with water absorption bands, compared with liquid samples. The best equation for transflectance method (liquid samples) obtained a higher coefficient of determination for calibration (0·95 vs. 0·94, respectively) and cross validation (0·94 vs. 0·91, respectively), and a lower error of cross validation (9·03 vs. 11·5, respectively) than the best equation for reflectance method (DESIR samples). In final, both methods showed excellent capacity for quantitative analysis, with residual predictive deviations above 3. It is concluded that, regarding accuracy of prediction and time for obtaining results of IgG from bovine colostrum, NIRS analysis of liquid samples (transflectance) is recommended over dried samples (DESIR technique by reflectance).
An International Comparison on industrial Platinum Resistance Thermometers (PRTs) among the National Metrology Institutes (NMIs) of Spain, Panama, Honduras, El Salvador, Costa Rica and Nicaragua began in 2013 and was successfully completed in 2014. Two PRTs were circulated (hand carried) and compared in the range from -38.8 °C up to 250 °C. The Centro Español de Metrología (Spanish NMI), CEM, acted as the pilot laboratory providing the reference value of the comparison.The thermometers have shown an acceptable behavior throughout the comparison, therefore the results can be considered valid for comparing the measurement capabilities of the participant laboratories. The equivalence between the participant laboratories in the calibration of platinum resistance thermometers by comparison in the range from -38,8 °C up to 250 °C has been demonstrated in almost all cases.This report presents the results of this comparison and provides detailed information of the measurements performed by the participating laboratories.Main text. To reach the main text of this paper, click on Final Report. Note that this text is that which appears in Appendix B of the BIPM key comparison database kcdb.bipm.org/.The final report has been peer-reviewed and approved for publication by the CCT, according to the provisions of the CIPM Mutual Recognition Arrangement (CIPM MRA).
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.