No abstract

No abstract

No abstract

The objective of this paper is to examine the sensitivity of fuel moisture to changes in temperature and precipitation and explore the implications under a future climate. We use the Canadian Forest Fire Weather Index System components to represent the moisture content of fine surface fuels (Fine Fuel Moisture Code, FFMC), upper forest floor (duff) layers (Duff Moisture Code, DMC) and deep organic soils (Drought Code, DC). We obtained weather data from 12 stations across Canada for the fire season during the 1971-2000 period and with these data we created a set of modified weather streams from the original data by varying the daily temperatures by 0 to +5°C in increments of 1°C and the daily precipitation from −40 to 40 % in increments of 10 %. The fuel moistures were calculated for all the temperature and precipitation combinations. When temperature increases we find that for every degree of warming, precipitation has to increase by more than 15 % for FFMC, about 10 % for DMC and about 5 % for DC to compensate for the drying caused by warmer temperatures. Also, we find in terms of the number of days equal to or above an FFMC of 91, a critical value for fire spread, that no increase in precipitation amount alone could compensate for a temperature increase of 1°C. Results from three General Circulation Models (GCMs) and three emission scenarios suggest that this sensitivity to temperature increases will result in a future with drier fuels and a higher frequency of extreme fire weather days.

New estimates of greenhouse gas emissions from Canadian forest fires were calculated based on a revised model for fuel consumption, using both the fire fuel load and the Drought Code of the Canadian Forest Fire Weather Index System. This model was applied to future climate scenarios of 2×CO2 and 3×CO2 environments using the Canadian Global Climate Model. Total forest floor fuel consumption for six boreal ecozones was estimated at 60, 80, and 117 Tg dry biomass for the 1×CO2, 2×CO2, and 3×CO2 scenarios, respectively. These ecozones cover the boreal and taiga regions and account for about 86% of the total fire consumption for Canada. Almost all of the increase in fuel consumption for future climates is caused by an increase in the area burned. The effect of more severe fuel consumption density (kilograms of fuel consumed per square metre) is relatively small, ranging from 0% to 18%, depending on the ecozone. The emissions of greenhouse gases from all Canadian fires are estimated to increase from about 162 Tg·year–1 of CO2 equivalent in the 1×CO2 scenario to 313 Tg·year–1 of CO2 equivalent in the 3×CO2 scenario, including contributions from CO2, CH4, and N2O.

Abstract. The Canadian Forest Fire Weather Index (FWI)System is the mostly widely used fire danger rating system in the world. We have developed a global database of daily FWI System calculations, beginning in 1980, called the Global Fire WEather Database (GFWED) gridded to a spatial resolution of 0.5 • latitude by 2/3 • longitude. Input weather data were obtained from the NASA Modern Era RetrospectiveAnalysis for Research and Applications (MERRA), and two different estimates of daily precipitation from rain gauges over land. FWI System Drought Code calculations from the gridded data sets were compared to calculations from individual weather station data for a representative set of 48 stations in North, Central and South America, Europe, Russia, Southeast Asia and Australia. Agreement between gridded calculations and the station-based calculations tended to be most different at low latitudes for strictly MERRAbased calculations. Strong biases could be seen in either direction: MERRA DC over the Mato Grosso in Brazil reached unrealistically high values exceeding DC = 1500 during the dry season but was too low over Southeast Asia during the dry season. These biases are consistent with those previously identified in MERRA's precipitation, and they reinforce the need to consider alternative sources of precipitation data. GFWED can be used for analyzing historical relationships between fire weather and fire activity at continental and global scales, in identifying large-scale atmosphere-ocean controls on fire weather, and calibration of FWI-based fire prediction models.

Introduction: The Canadian Forest Fire Danger Rating System (CFFDRS) is a globally known wildland fire risk assessment system, and two major components, the fire weather index system and the fire behavior prediction system, have been extensively used both nationally and internationally to aid operational wildland fire decision making. Methods: In this paper, we present an overview of an R package cffdrs, which is developed to calculate components of the CFFDRS, and highlight some of its functionality. In particular, we demonstrate how these functions could be used for large data analysis. Results and Discussion: With this cffdrs package, we provide a portal for not only a collection of R functions dealing with all available components in CFFDRS but also a platform for various additional developments that are useful for the understanding of fire occurrence and behavior. This is the first time that all relevant CFFDRS methods are incorporated into the same platform, which can be accessed by both the management and research communities.

In 2019 the Canadian Space Agency initiated development of a dedicated wildfire monitoring satellite (WildFireSat) mission. The intent of this mission is to support operational wildfire management, smoke and air quality forecasting, and wildfire carbon emissions reporting. In order to deliver the mission objectives, it was necessary to identify the technical and operational challenges which have prevented broad exploitation of Earth Observation (EO) in Canadian wildfire management and to address these challenges in the mission design. In this study we emphasize the first objective by documenting the results of wildfire management end-user engagement activities which were used to identify the key Fire Management Functionalities (FMFs) required for an Earth Observation wildfire monitoring system. These FMFs are then used to define the User Requirements for the Canadian Wildland Fire Monitoring System (CWFMS) which are refined here for the WildFireSat mission. The User Requirements are divided into Observational, Measurement, and Precision requirements and form the foundation for the design of the WildFireSat mission (currently in Phase-A, summer 2020).