No abstract

Brazil is the second largest soybean producer in the world, with a yield of around 96.2 million tons per crop. This high yield leads to a great amount of waste resulting from soybean cultivation, which can reach approximately 41 million tons of waste per year. This material has lignocellulosic properties, which may enable its use as a raw material for particleboard production. Therefore, the objective of this study was to evaluate the use of soybean pods in particleboard production. For particleboard manufacture, wood of the hybrid Eucalyptus urophylla and Eucalyptus grandis was used, added with soybean pods, at proportions of 0%, 25%, 50%, 75% and 100%. For particleboard evaluation, a completely randomized design was used, with five treatments and three replicates, using linear regression and the Scott-Knott test at 5% significance for comparison among the different treatments. The properties apparent density, compaction ratio, water absorption after 2 and 24 hours, thickness swelling after 2 and 24 hours in water immersion, internal bonding, modulus of rupture and modulus of elasticity in bending properties were evaluated. The ratio soybean pod waste and eucalyptus particles in the panels led to an increase in water absorption values and thickness swelling, in addition to a decrease in mechanical properties. The production of panels with approximately 23% soybean pods is feasible.

No abstract

No abstract

No abstract

No abstract

No abstract

The present study has the objective of evaluating the physical-mechanical properties of plywood produced with Acrocarpus fraxinifolius wood, as well as the effect of combining their veneer with Pinus veneer. The wood of Acrocarpus fraxinifolius and Pinus oocarpa were used in the production of the panels. The plywood was produced with five veneers; the adhesive used was phenol-formaldehyde, weighing 320 g.m -2 . The evaluated properties were: equilibrium moisture (EM), specific mass (SM), water absorption (WA), thickness swelling (TS), shear strength (SS), modulus of rupture (MOR) and modulus of elasticity (MOE) both parallel and perpendicular to the fibers. No statistical difference was observed in the EM and TS, whereas all other properties showed statistical differentiation between the treatments. In general, the use of Acrocarpus fraxinifolius veneers improved the physical-mechanical properties of the compensated ones. Thus, the use of this species in the production of plywood is technically feasible.