The use of worn-out agricultural nozzles in pesticide application has a negative effect on the efficiency and cost of the application process. It also has an effect on environmental pollution due to an excessive amount of pesticide being applied when spraying with worn-out nozzles. In this paper, the resistance to wear of three different internal design hydraulic nozzles was ascertained. Changes in the flow rate and spray distribution as a result of this wear were also investigated. The wear test was done inside a closed system, and it was accelerated using an abrasive material to generate 100 h of wear. The tested nozzles were the Turbo TeeJet (TT)-twin chambered, Turbo Twinjet (TTj60)-dual outlet, and Drift Guard (DG)-pre-orifice. Wear rate, flow rate, and the virtual coefficient of variation (CVv) were measured at different wear intervals. The results showed that the TTj60 type was the most resistant to wear, followed by the TT type and DG. The latter two types showed an increase in the flow rate only in the first 45 h of wear. Virtual coefficient of variation (CVv) values were less than 10% after finishing the test (after 100 h of wear) for the three types of nozzles, which are acceptable values according to International Organization for Standardization (ISO) 16122-2, 2015.
This paper presents an analysis of selected qualitative characteristics of pellets produced from rape straw obtained from cultivations subjected to different fertilization treatments and from mixtures of straw selected for testing with crude glycerol obtained as a by-product from biodiesel production. The assessment focused on the following qualities of the obtained pellets: Moisture content, mechanical durability, heating value and main elements, that is, carbon, hydrogen, nitrogen, sulphur, chlorine and oxygen. The obtained results indicated that the different treatment regimens applied in spring rape cultivations had a significant impact on the physicochemical qualities of the straw. In terms of the heating value, traditional fertilization with multi-component fertilizer (NPK) yielded slightly lower chemical parameters (lower carbon content and heat of combustion) than in the case of straw obtained from the control sample and from the plot fertilized with digestate. Furthermore, in all of the analysed mixtures, the 10% addition of raw glycerol improved the mechanical characteristics of the produced straw pellets. After the 10% glycerol addition, in terms of the energetic use of these biofuels, the parameters of the fuel, such as heating value and net heating value, were slightly decreased.
The field experiment was conducted with the aim of developing and testing an automatic sprayer for agricultural spray experiments and studying the effect of spray pressure, spray speed and spray height on the spraying process. The effects of the major spraying factors (pressure, speed, and height) on the spraying performance of the automatic sprayer were studied. This study included several traits: First - the drop sizes - Second - the penetration of the spray into the vegetation cover - Third, the spray wasted. The results showed: - First: - Increase in coverage percentage when using the first speed, 2 km / h, which amounted to 26.85%. An increment in the spraying penetration of the vegetation cover was observed at the second speed, 4 km/h, reaching 70%. Second - Pressure: The increment in pressure was accompanied by an increment in the coverage trait at the third pressure 3 bar, which amounted to 24.37%. The penetration trait was 81% at pressure of two bar, and wastage increased at the second pressure of two bar, which amounted to 25%. Spraying height: - Height) 40 & 50 cm (have no significant effect on the trait of coverage. However, it was significant in the trait of spraying penetration of the vegetation cover, as it reached at the first height (40 cm) 53% and at the second height (50 cm) 74%, and the trait of the lost at the first height, 40 cm was 13%, and at the second height, 50 cm, it reached 23%. It is concluded from the data, the extent of the effect that the spraying factors show on the studied trait, as The factors value increased is accompanied by an increment in some trait, in contrast to others. So, it becomes clear the necessity of coordinating the values of the factors with each other to obtain an equal spray.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.