The fundamental aspects of the manufacturing of gold nanoparticles (AuNPs) are discussed in this review. In particular, attention is devoted to the development of a simple and versatile method for the preparation of these nanoparticles. Eco-friendly synthetic routes, such as wet chemistry and biosynthesis with the aid of polymers, are of particular interest. Polymers can act as reducing and/or capping agents, or as soft templates leading to hybrid nanomaterials. This methodology allows control of the synthesis and stability of nanomaterials with novel properties. Thus, this review focus on a fundamental study of AuNPs properties and different techniques to characterize them, e.g., Transmission Electron Microscopy (TEM), Atomic Force Microscopy (AFM), UV-Visible spectroscopy, Dynamic Light Scattering (DLS), X-Ray Diffraction (XRD), X-Ray Photoelectron Spectroscopy, Small-angle X-Ray Scattering (SAXS), and rheology. Recently, AuNPs obtained by “green” synthesis have been applied in catalysis, in medicine, and as antibacterials, sensors, among others.
In this work, a novel route is discussed to produce in one step ZnO/Burkeite powders by the modified solution combustion method. The ZnO particles enhance the photocatalytic activity in the degradation of Rhodamine B, in which Burkeite mineral acts as a support due to the pH-dependent morphology of the particle aggregates of the as-synthesized powders. The X-ray diffraction (XRD) characterization shows the presence of a heterostructure: ZnO/Burkeite. The Scanning Electron Microscopy (SEM) image shows a morphological dependence with the pH of the solution used for the synthesis. The results show that the system with the highest degradation (92.4%) corresponds to the case in which ZnO/Burkeite heterostructure was synthesized with a pH 11.
This work is focused on making a correlation between results obtained by using spectroscopy and microscopy techniques from single and twofold-layer Silicon-Rich Oxide (SRO) films. SRO films single-layer and twofold-layer characterizations were compared considering the conditions as-grown and with thermal treatment at 1100 °C for 60 min in a nitrogen atmosphere. The thickness of the single-layer film is 324.7 nm while for the twofold-layer film it is 613.2 nm; after heat-treated, both thicknesses decreased until 28.8 nm. X-ray Photoelectron Spectroscopy shows changes in the excess-silicon in single-layer SRO films, with 10% in as-grown films and decreases to 5% for the heat-treated films. Fourier Transform Infrared Spectroscopy (FTIR) exhibits three characteristic vibrational modes of SiO2, as well as, the vibrating modes associated with the Si-H bonds, which disappear after the heat treatment. With UV–Vis spectroscopy results we obtained the absorbance and the absorption coefficient for the SRO films in order to calculate the optical bandgap energy (Egopt), which increased with heat-treatment. The energy peaks of the photoluminescence spectra were used to calculate the silicon nanocrystal size, obtaining thus an average size of 1.89 ± 0.32 nm for the as-grown layer, decreasing the size to 1.64 ± 0.01 nm with the thermal treatment. On the other hand, scanning electron microscopy and high-resolution transmission electron microscopy images confirm the thickness of the twofold-layer SRO films as 628 nm for the as-grown layer and 540 nm for the layer with heat-treatment, and the silicon nanocrystal size of 2.3 ± 0.6 nm for the films with thermal treatment.
Dilute aqueous solutions of triblock copolymer Pluronic P103 were used to synthesize silver nanoparticles (Ag-NPs) by chemical reduction of silver nitrate (AgNO3) with sodium borohydride (NaBH4). This copolymer was used as a structural agent since monomers act as a stabilizer and micelles act as nanoreactors for nucleation and growth of Ag-NPs. The growth of the nanoparticles (NPs) was monitored by UV-visible spectroscopy on the basis of measuring surface plasmon resonance absorption over a temperature range of 25 to 70°C. Shape and size of hybrid silver/P103 nanomaterials were tuned by varying the micellar structure of Pluronic P103 using a simple synthesis procedure. Dynamic Light Scattering (DLS) and Transmission Electron Microscopy (TEM) were used to study the size and shape of the hybrid nanomaterials. It was observed that Ag-NPs synthesized without Pluronic P103 at 25°C exhibited a great variety of sizes. However, when Pluronic P103 was used below its critical micellar concentration (CMC), spherical-shaped Ag-NPs with uniform size were formed, suggesting that the copolymer had a stabilizing effect. On the other hand, when Ag-NPs were prepared with Pluronic P103 above the CMC, NPs with similar sizes as the micelles were detected, suggesting that the copolymer functioned as a nanoreactor. Furthermore, as temperature reached 35°C, oval-shaped micelles were formed and small NPs were incorporated into the crown of the micelles. Independent Ag-NPs were not observed since they used the surface of the micelles as a soft template. Therefore, it was possible to obtain tiny Ag-NPs with homogeneous size.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.