In urban areas of Brazil, vehicle emissions are the principal source of fine particulate matter (PM2.5). The World Health Organization air quality guidelines state that the annual mean concentration of PM2.5 should be below 10 μg m−3. In a collaboration of Brazilian institutions, coordinated by the University of São Paulo School of Medicine and conducted from June 2007 to August 2008, PM2.5 mass was monitored at sites with high traffic volumes in six Brazilian state capitals. We employed gravimetry to determine PM2.5 mass concentrations, reflectance to quantify black carbon concentrations, X-ray fluorescence to characterize elemental composition, and ion chromatography to determine the composition and concentrations of anions and cations. Mean PM2.5 concentrations and proportions of black carbon (BC) in the cities of São Paulo, Rio de Janeiro, Belo Horizonte, Curitiba, Recife, and Porto Alegre were 28.1 ± 13.6 μg m−3 (38% BC), 17.2 ± 11.2 μg m−3 (20% BC), 14.7 ± 7.7 μg m−3 (31% BC), 14.4 ± 9.5 μg m−3 (30% BC), 7.3 ± 3.1 μg m−3 (26% BC), and 13.4 ± 9.9 μg m−3 (26% BC), respectively. Sulfur and minerals (Al, Si, Ca, and Fe), derived from fuel combustion and soil resuspension, respectively, were the principal elements of the PM2.5 mass. We discuss the long-term health effects for each metropolitan region in terms of excess mortality risk, which translates to greater health care expenditures. This information could prove useful to decision makers at local environmental agencies.

In Brazil, the principal source of air pollution is the combustion of fuels (ethanol, gasohol, and diesel). In this study, we quantify the contributions that vehicle emissions make to the urban fine particulate matter (PM2.5) mass in six state capitals in Brazil, collecting data for use in a larger project evaluating the impact of air pollution on human health. From winter 2007 to winter 2008, we collected 24-h PM2.5 samples, employing gravimetry to determine PM2.5 mass concentrations; reflectance to quantify black carbon concentrations; X-ray fluorescence to characterize elemental composition; and ion chromatography to determine the composition and concentrations of anions and cations. Mean PM2.5 concentrations in the cities of São Paulo, Rio de Janeiro, Belo Horizonte, Curitiba, Porto Alegre, and Recife were 28, 17.2, 14.7, 14.4, 13.4, and 7.3 μg/m3, respectively. In São Paulo and Rio de Janeiro, black carbon explained approximately 30% of the PM2.5 mass. We used receptor models to identify distinct source-related PM2.5 fractions and correlate those fractions with daily mortality rates. Using specific rotation factor analysis, we identified the following principal contributing factors: soil and crustal material; vehicle emissions and biomass burning (black carbon factor); and fuel oil combustion in industries (sulfur factor). In all six cities, vehicle emissions explained at least 40% of the PM2.5 mass. Elemental composition determination with receptor modeling proved an adequate strategy to identify air pollution sources and to evaluate their short- and long-term effects on human health. Our data could inform decisions regarding environmental policies vis-à-vis health care costs.

No abstract

Abstract. The notable increase in biofuel usage by the road transportation sector in Brazil during recent years has significantly altered the vehicular fuel composition. Consequently, many uncertainties are currently found in particulate matter vehicular emission profiles. In an effort to better characterise the emitted particulate matter, measurements of aerosol physical and chemical properties were undertaken inside two tunnels located in the São Paulo Metropolitan Area (SPMA). The tunnels show very distinct fleet profiles: in the Jânio Quadros (JQ) tunnel, the vast majority of the circulating fleet are light duty vehicles (LDVs), fuelled on average with the same amount of ethanol as gasoline. In the Rodoanel (RA) tunnel, the particulate emission is dominated by heavy duty vehicles (HDVs) fuelled with diesel (5 % biodiesel). In the JQ tunnel, PM 2.5 concentration was on average 52 µg m −3 , with the largest contribution of organic mass (OM, 42 %), followed by elemental carbon (EC, 17 %) and crustal elements (13 %). Sulphate accounted for 7 % of PM 2.5 and the sum of other trace elements was 10 %. In the RA tunnel, PM 2.5 was on average 233 µg m −3 , mostly composed of EC (52 %) and OM (39 %). Sulphate, crustal and the trace elements showed a minor contribution with 5 %, 1 %, and 1 %, respectively. The average OC : EC ratio in the JQ tunnel was 1.59 ± 0.09, indicating an important contribution of EC despite the high ethanol fraction in the fuel composition. In the RA tunnel, the OC : EC ratio was 0.49 ± 0.12, consistent with previous measurements of diesel-fuelled HDVs. Besides bulk carbonaceous aerosol measurement, polycyclic aromatic hydrocarbons (PAHs) were quantified. The sum of the PAHs concentration was 56 ± 5 ng m −3 and 45 ± 9 ng m −3 in the RA and JQ tunnel, respectively. In the JQ tunnel, benzo(a)pyrene (BaP) ranged from 0.9 to 6.7 ng m −3 (0.02-0. 1 ‰ of PM 2.5 ) whereas in the RA tunnel BaP ranged from 0.9 to 4.9 ng m −3 (0.004-0. 02 ‰ of PM 2.5 ), indicating an important relative contribution of LDVs emission to atmospheric BaP.Real-time measurements performed in both tunnels provided aerosol size distributions and optical properties. The average particle count yielded 73 000 cm −3 in the JQ tunnel and 366 000 cm −3 in the RA tunnel, with an average diameter of 48 nm in the former and 39 nm in the latter. Aerosol single scattering albedo, calculated from scattering and absorption observations in the JQ tunnel, indicates a value of 0.5 associated with LDVs. Such single scattering albedo is 20-50 % higher than observed in previous tunnel studies, possibly as a result of the large biofuel usage. Given the exceedingly high equivalent black carbon loadings in the RA tunnel, real time light absorption measurements were possible only in the JQ tunnel. Nevertheless, using EC measured from the filters, a single scattering albedo of 0.31 for the RA tunnel has been estimated. The results presented here characterise particulate matter emitted from nearly 1 million vehicles fuelled with a considerable amount of...

In the metropolitan area of São Paulo, Brazil, ozone and particulate matter (PM) are the air pollutants that pose the greatest threat to air quality, since the PM and the ozone precursors (nitrogen oxides and volatile organic compounds) are the main source of air pollution from vehicular emissions. Vehicular emissions can be measured inside road tunnels, and those measurements can provide information about emission factors of in-use vehicles. Emission factors are used to estimate vehicular emissions and are described as the amount of species emitted per vehicle distance driven or per volume of fuel consumed. This study presents emission factor data for fine particles, coarse particles, inhalable particulate matter and black carbon, as well as size distribution data for inhalable particulate matter, as measured in March and May of 2004, respectively, in the Jânio Quadros and Maria Maluf road tunnels, both located in São Paulo. The Jânio Quadros tunnel carries mainly light-duty vehicles, whereas the Maria Maluf tunnel carries light-duty and heavy-duty vehicles. In the Jânio Quadros tunnel, the estimated light-duty vehicle emission factors for the trace elements copper and bromine were 261 and 220 microg km(-1), respectively, and 16, 197, 127 and 92 mg km(-1), respectively, for black carbon, inhalable particulate matter, coarse particles and fine particles. The mean contribution of heavy-duty vehicles to the emissions of black carbon, inhalable particulate matter, coarse particles and fine particles was, respectively 29, 4, 6 and 6 times higher than that of light-duty vehicles. The inhalable particulate matter emission factor for heavy-duty vehicles was 1.2 times higher than that found during dynamometer testing. In general, the particle emissions in São Paulo tunnels are higher than those found in other cities of the world.

Burning of fuels from the transport sector is one of the main sources of air pollutants emission in urban areas. In order to implement public policies concerning air quality and public health, there is a need to develop emission inventories. Measurements inside traffic tunnels can provide an evaluation of emission factors of vehicles in-use in real conditions. In this paper, we show measurements of air pollutants for a mixed vehicle fleet, heavyand light-duty vehicles (HDVs and LDVs), in two tunnels in the metropolitan region of Sao Paulo in 2011 in order to calculate the pollutant emission factors (EFs). Measurements of carbon dioxide, carbon monoxide (CO), nitrogen oxides (NO x ) and particle matter (PM 2.5 ) were taken. High concentrations related to high-density traffic, especially during weekdays. EFs were heavily influenced by the pollutant species loads, so the total vehicle traffic and the fraction of HDV. The EF values for HDV were 3.6 and 9.2 g km -1 , for CO and NO x , respectively (5.8 and 0.3 g km -1 for LDV). To determine EF estimates, parameters such as velocity of the air, cross-sectional area and length of the tunnel and vehicles passing at 1-h time interval were considered.

No abstract

No abstract