No abstract

Titanium is the main component of dental implants. It is also routinely used as a framework material for implant-supported full-arch prostheses due to its low density, biocompatibility, and other mechanical properties. Remarkable mechanical properties such as lesser mass density and higher young’s modulus of graphene have gained popularity among scientists, improving the properties of biomedical implants. Thus, our study aimed to compare the outcome through the von Mises stresses generated on All-on-6 and All-on-3 implant models, as well as on the framework, and evaluate the effect of stress patterns on the crestal bone around implants in the mandible. FEA (Finite Element Analysis) study was carried out using edentulous mandible models. Four 3D FEA models with 3 and 6 implants were used (Model 1: Titanium bar-supported 6 straight implants; Model 2: Graphene bar-supported 6 straight implants; Model 3: Titanium bar-supported 3 implants with 30 degrees-tilted; Model 4: Graphene bar-supported 3 implants with 30 degrees-tilted) in order to simulate endosseous implant designs. The implant measuring 4.2 mm in diameter and 11.5 mm in length were used. The most distal implants in the 3-implant models were placed with angulation of 30 degrees; in 6 implants, they were vertically placed. All the models were analyzed for vertical and oblique axis with a single force magnitude of 100 N. In all four implant models and under loading conditions, the peak stress points were always on the neck of the most distal implant. von Mises stresses were within the normal stress range. In a conventional six-straight implant model supported by a titanium framework, the cortical stress in the region of implants was 25.27 MPa, whereas, in the graphene framework, it was 12.18 MPa. Under vertical load, there was a significant difference in the cortical stress around the tilted implants (30 degrees) in the 3-implant system of titanium and graphene frameworks, respectively, 70.31 MPa and 21.27 MPa. The graphene framework demonstrated better results than the titanium framework for the conventional six-implant system under vertical load, achieving stress of 30.09 MPa and 76.60 MPa, respectively. In the case of the 3-implant system, a significant difference in the bar stress was observed between graphene and titanium, respectively, 256.32 MPa and 180.1 MPa of bar stress. Within the limitation of this study, the peri-implant stresses were decreased using graphene framework models. Hence, it was possible to conclude that the best load-bearing capacity results were found in the graphene framework group compared to the titanium framework for All-on-6 and All-on-3 implant models, even though both materials are reliable options used as framework materials in implant-supported full-arch prostheses.

Dental professionals are playing an imperative role in the healthcare system. It is important to distribute the dental workforce across the country. Therefore, this study aimed at analyzing the recent distribution of the dental workforce in the Kingdom of Saudi Arabia (KSA) and determining the current dentist-to-population ratio in the KSA. This is a cross-sectional study focused on the dental workforces working in the KSA between 2015 and 2020. Complete data of dentists working in the KSA with different professional ranks were obtained. The data were stratified by gender, professional rank (Saudi and non-Saudi), area of working (13 provinces in the KSA), and sector of working (public and private). A complete list of all dental universities was obtained to identify the increasing number of dental institutes at this current moment. In addition, the dentist-to-population ratio was also evaluated based on the current inhabitant in the KSA and the total dental surgeons. There are a total of 27181 dental surgeons and 8022 dental auxiliaries registered in different specialties as of 2020. Saudi citizens are holding the majority of the posts in both dentist and dental auxiliary categories. The percentage of males and female is slightly higher in dentists and dental auxiliaries, respectively. It also indicated that where most of the dental personnel work in the private sector, dental auxiliaries work in the public sector. Moreover, the highest number of dental workforces is identified in the Riyadh region among all the 13 provinces. Based on the databases, the current dentist-to-population ratio is 1 : 1288.16. In conclusion, the number of dental professionals is ample; however, rural areas lack specialists. Saudi dentists are progressively replacing foreign dentists in different professional ranks working in the KSA.

Background: It is essential for practicing dentists to have adequate knowledge of HIV/AIDS and its implications in the dental practice. Their attitudes should also be up to the professional expectations. This study aimed to assess knowledge of HIV/AIDS infection and attitudes towards its patients among dental students in Saudi Arabia. Methods: A questionnaire was prepared and distributed among a sample of dental students in Saudi Arabia. Twenty questions related to knowledge, attitudes, and oral manifestation of HIV were presented. Results: A total of 405 questionnaires were completed (67% response rate). Participants showed low knowledge of safety regarding HIV (39.5%) and 44.2% indicated that they would take an HIV test after needle stick injury. The proportion of correct answers regarding transmission of HIV through saliva, cardiopulmonary resuscitation, and aerosols by hand pieces was 41%, 37.5%, and 26.4%, respectively. Almost 50% of the surveyed dental students expressed unwillingness to treat HIV-positive patients. Poor knowledge was noted regarding oral manifestations of HIV (32.7%). Of the participants, 57.8% indicated that infection control procedures are very important for the treatment of HIV patients and 50.6% believed that a dentist can make a decision to reject the treatment of HIV patients. According to the participating dental students, the three major oral manifestations in HIV patients are hairy leukoplakia (47.4%), oral candidiasis (44.7%), and Kaposi’s sarcoma (43.5%). Conclusion: Inadequate knowledge and unprofessional attitude towards HIV/AIDS patients were identified among this group of dental students in Saudi Arabia. Dental educators and health care planners in Saudi Arabia should plan to promote the knowledge and attitudes of dental students in Saudi Arabia towards the treatment of HIV patients.

Background and Objectives: The most common treatment procedure for periodontitis and gingivitis is scaling and root planing, which is perceived as a painful dental treatment. The current study aimed to assess pain perception and analgesics consumption after scaling and root planing (SRP) in patients with stage II and stage III periodontitis. Materials and Methods: Before starting the SRP, all the periodontal parameters, such as probing depth (PD), bleeding on probing (BOP), and clinical attachment level (CAL), were measured. The anxiety level of the patients was also assessed using the modified dental anxiety scale (MDAS) questionnaire. Pain perception of the patients was recorded with the visual analog scale (VAS) after performing the SRP. Patients were asked to mark their pain level on the VAS sheet after two hours, four hours, eight hours, 24 h, and 48 h after the periodontal treatment. The following cut-off points were used for the pain intensity in the VAS: 0 = no pain, 1–4 = mild pain, 4–6 = moderate pain, and 7–10 = severe pain. Patients were advised to take analgesics if the pain was intolerable. Multivariate logistic regression was performed to conduct the association of all dependent variables and the pain perception of patients. A nonparametric Friedman test was conducted to assess pain perception at different times. Results: A total of 52 patients including 32 males and 20 females participated in the current study, with a mean age of 43.10 ± 12.33 years. Multivariate analyses showed that MDAS and analgesic consumption is significantly associated with pain perception. Other clinical variables are not associated with pain perception. The Friedman test exhibited that pain perception is significantly associated (p < 0.05) with time. Conclusions: Analgesic consumption and anxiety level are significantly associated with pain perception after SRP treatment.