A range of binary, ternary (CFS), and quaternary (CZTS) metal sulfide materials have been successfully deposited onto the glass substrates by air-spray deposition of metal diethyldithiocarbamate molecular precursors followed by pyrolysis (18 examples). The as-deposited materials were characterized by powder X-ray diffraction (p-XRD), Raman spectroscopy, secondary electron microscopy (SEM), and energy-dispersive X-ray (EDX) spectroscopy, which in all cases showed that the materials were polycrystalline with the expected elemental stoichiometry. In the case of the higher sulfides, EDX spectroscopy mapping demonstrated the spatial homogeneity of the elemental distributions at the microscale. By using this simple and inexpensive method, we could potentially fabricate thin films of any given main group or transition metal chalcogenide material over large areas, theoretically on substrates with complex topologies.
In the present work we report on the synthesis of tetragonal stannite Cu 2 FeSnS 4 powders using a solvent free melt method using a mixture of Cu, Fe, and Sn(II)/Sn(IV) O-ethylxanthates heated at different temperatures. The as-synthesized powders were characterized by powder X-ray diffraction (p-XRD), Raman spectroscopy, X-ray photoelectron spectroscopy (XPS), UV-Vis absorption spectroscopy, scanning electron microscopy (SEM) and energy dispersive X-ray (EDX) spectroscopy, which confirm the successful synthesis of stannite CFTS. Optical measurements show that Cu 2 FeSnS 4 powders have visible light absorption onsets in the far red with direct band gap energies in the range 1.32-1.39 eV which are suitable for acting as efficient absorber layers in solar cells. Electronic characterisation of these materials deposited as thin films by spin coating show that they are p type semiconductors with respectable carrier mobilities of ca. 60 cm 2 V À1 s À1 with carrier densities on the order of 10 14 cm À1 .
Manganese(II) xanthate complexes of the form [Mn-(S 2 COR) 2 (TMEDA)], where TMEDA = tetramethylethylenediamine and R = methyl (1), ethyl (2), n-propyl (3), n-butyl (4), n-pentyl (5), n-hexyl (6), and noctyl (7), have been synthesized and structures elucidated using single-crystal X-ray diffraction. Complexes 1−7 were used as molecular precursors to synthesize manganese sulfide (MnS). Olelyamine-capped nanocrystals have been produced via hot injection, while the doctor blading followed by thermolysis yielded thick films. Free-standing polycrystalline powders of MnS are produced by direct thermolysis of precursor powders. All thermolysis techniques produced cubic MnS, as confirmed by powder X-ray diffraction, scanning electron microscopy, energydispersive X-ray spectroscopy, and Raman spectroscopy. Magnetic measurements reveal that the α-MnS nanocrystals exhibit ferromagnetic behavior with a large coercive field strength (e.g., 0.723 kOe for 6.8 nm nanocrystals).
Four 3d−4f hetero-polymetallic complexes [Fe 2 Ln 2 ((OCH 2 ) 3 CR) 2 (O 2 C t Bu) 6 (H 2 O) 4 ] (where Ln = La (1 and 2) and Gd (3 and 4); and R = Me (1 and 3) and Et (2 and 4)) are synthesized and analyzed using elemental analysis, Fourier transform infrared spectroscopy, thermogravimetric analysis, and SQUID magnetometry. Crystal structures are obtained for both methyl derivatives and show that the complexes are isostructural and adopt a defective dicubane topology. The four heavy metals are connected with two alkoxide bridges. These four precursors are used as single-source precursors to prepare rare-earth orthoferrite pervoskites of the form LnFeO 3 . Thermal decomposition in a ceramic boat in a tube furnace gives orthorhombic LnFeO 3 powders using optimized temperatures and decomposition times: LaFeO 3 formed at 650 °C over 30 min, whereas GdFeO 3 formed at 750 °C over 18 h. These materials are structurally characterized using powder X-ray diffraction, Raman spectroscopy, scanning electron microscopy, energy-dispersive X-ray map spectroscopy, and SQUID magnetometry. EDX spectroscopy mapping reveals a homogeneous spatial distribution of elements for all four materials consistent with LnFeO 3 . Magnetic measurements on complexes 1−4 confirm the presence of weak antiferromagnetic coupling between the central Fe(III) ions of the clusters and negligible ferromagnetic interaction with peripheral Gd(III) ions in 3 and 4. Zero-field-cooled and field-cooled measurements of magnetization of LaFeO 3 and GdFeO 3 in the solid-state suggest that both materials are ferromagnetic, and both materials show open magnetic hysteresis loops at 5 and 300 K, with M sat higher than previously reported for these nanomaterials. We conclude that this is a new and facile low temperature route to these important magnetic materials that is potentially universal, limited only by what metals can be programmed into the precursor complexes.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.