No abstract

No abstract

No abstract

Increasing water and fertilizer productivity stands as a relevant challenge for sustainable agriculture. Alternate furrow irrigation and surface fertigation have long been identified as water and fertilizer conserving techniques in agricultural lands. The objective of this study was to simulate water flow and fertilizer transport in the soil surface and in the soil profile for variable and fixed alternate furrow fertigation and for conventional furrow fertigation. An experimental data set was used to calibrate and validate two simulation models: a 1D surface fertigation model and the 2D subsurface water and solute transfer model HYDRUS-2D. Both models were combined to simulate the fertigation process in furrow irrigation. The surface fertigation model could successfully simulate runoff discharge and nitrate concentration for all irrigation treatments. Six soil hydraulic and solute transport parameters were inversely estimated using the Levenberg-Marquardt optimization technique. The outcome of this process calibrated HYDRUS-2D to the observed field data. HYDRUS-2D was run in validation mode, simulating water content and nitrate concentration in the soil profiles of the wet furrows, ridges and dry furrows at the upstream, middle and downstream parts of the experimental field. This model produced adequate agreement between measured and predicted soil water content and nitrate concentration. The combined model stands as a valuable tool to better design and manage fertigation in alternate and conventional furrow irrigation.

No abstract

No abstract

Alternate furrow fertigation has shown potential to improve water and fertilizer application efficiency in irrigated areas. The combination of simulation and optimization approaches permits to identify optimum design and management practices in furrow fertigation, resulting in optimum cost, irrigation performance or environmental impact. The objective of this paper is to apply 1D surface and 2D subsurface simulation-optimization models to the minimization of nitrate losses in two types of alternate furrow fertigation: a) variable alternate furrow irrigation; and b) fixed alternate furrow irrigation. For comparison purposes, optimizations are also reported for conventional furrow irrigation. The model uses numerical surface fertigation and soil water models to simulate water flow and nitrate transport in the soil surface and subsurface, respectively. A genetic algorithm is used to solve the optimization problem. Four decision variables (inflow discharge, cutoff time, start time and duration of fertilizer solution injection) were optimized to minimize the selected objective function (nitrate loss) for two fertigation events performed during a maize growing season. The simulation-optimization model succeeded in substantially reducing the value of the objective function, as compared to the field conditions for all irrigation treatments. In the experimental conditions, optimization led to decreased inflow discharge and fertilizer injection during the first half of the irrigation event. This was due to the high potential of the field experiment to lose water and nitrate via runoff. In the optimum conditions, alternate furrow fertigation strongly reduced water and nitrate losses compared to conventional furrow irrigation. The simulation-optimization model stands as a valuable tool for the alleviation of the environmental impact of furrow irrigation.

No abstract