An investigation of molecular weight distributions (MWDs) resulting from initiation of free radical polymerization by an arbitrary sequence of short laser pulses has been undertaken. The analytical expressions have been derived to calculate MWDs for a polymerization scheme that contains reactions of chain initiation, propagation and termination by recombination or disproportionation. The MWDs produced by pulse-periodic irradiation have been calculated for a wide range of initiating pulses repetition rates (f = 0.05–100 Hz). The MWD dynamics in the act of polymerization and the influence of the duration of polymerization pseudostationary regime establishment upon the MWD have also been studied. The suitability of the derived expressions for describing the MWD generated by CW radiation before and after the establishment of polymerization quasi-stationary regime has been considered.

For polymerization initiated by an arbitrary sequence of laser pulses a numerical technique for calculating molecular weight distributions (MWDs) is developed, which takes into consideration the chain length dependence of the termination rate constant kt. The MWDs for methyl methacrylate and styrene are calculated by use of α and k0 values (for the law k titalici,j = k0(i)−α of termination of radicals with chain length i) and averages \documentclass{article}\pagestyle{empty}\begin{document}$ \overline {(i,{\rm }j)} $\end{document} (for rate constants k titalici,j = k0\documentclass{article}\pagestyle{empty}\begin{document}$ \overline {(i,{\rm }j)} $\end{document} of termination of radicals with different degrees of polymerization) taken from the literature. The dependences of the overall termination constant 〈kt〉 on initiation parameters (pulse repetition rate (v) and pulse intensity for initiation by periodic laser pulses) are presented. Two methods are proposed for α and k0 determination: (a) by experiments on polymerization with periodic laser pulses where monomer‐to‐polymer conversions per pulse are determined for different v; (b) by experiments on polymerization with packets of pulses where the constant kp (the rate constant of propagation), α and k0 can be determined simultaneously from MWD. For both methods simple analytical equations are derived for evaluation of the constants. The limits of application of the methods are determined by use of the numerical technique for MWD calculation.

Aspects of applying n‐pulse periodic initiation in pulsed laser polymerization/size‐exclusion chromatography (PLP/SEC) experiments are studied via simulation of molecular weight distributions (MWDs). In n‐pulse periodic PLP/SEC, sequences of n laser pulses at successive time intervals Δt1 up to Δtn are periodically applied. With the dark time intervals being suitably chosen, n‐modal MWDs with n well separated peaks occur. The n‐pulse periodic PLP/SEC method has the potential for providing accurate propagation rate coefficients, kp. Among several measures for kp, the differences in molecular weights at the MWD peak positions yield the best estimate of kp under conditions of medium and high pulse laser‐induced free‐radical concentration. Deducing kp from n dark time intervals (corresponding to n regions of free‐radical chain length) within one experiment at otherwise identical PLP/SEC conditions allows addressing in more detail a potential chain‐length dependence of kp. Simulations are compared with experimental data for 2‐pulse periodic polymerization of methyl methacrylate.

No abstract

No abstract

No abstract

No abstract

No abstract