This letter reports on highly sensitive optical absorption measurements on organic donor-acceptor solar cells, using Fourier-transform photocurrent spectroscopy ͑FTPS͒. The spectra cover an unprecedented dynamic range of eight to nine orders of magnitude making it possible to detect defect and disorder related sub-band gap transitions. Direct measurements on fully encapsulated solar cells with an active layer of poly͓2-methoxy-5-͑3Ј ,7Ј -dimethyl-octyloxy͔͒-p-phenylene-vinylene:͑6,6͒-phenyl-C61-butyric-acid ͑1:4 weight ratio͒ enabled a study of the intrinsic defect generation due to UV illumination. Solar cell temperature annealing effects in poly͑3-hexylthiophene͒:PCBM ͑1:2 weight ratio͒ cells and the induced morphological changes are related to the changes in the absorption spectrum, as determined with FTPS.

Optical characterization methods were applied to a series of microcrystalline silicon thin films and solar cells deposited by the very high frequency glow discharge technique. Bulk and surface light scattering effects were analyzed. A detailed theory for evaluation of the optical absorption coefficient ␣ from transmittance, reflectance and absorptance ͑with the help of constant photocurrent method͒ measurements in a broad spectral region is presented for the case of surface and bulk light scattering. The spectral dependence of ␣ is interpreted in terms of defect density, disorder, crystalline/amorphous fraction and material morphology. The enhanced light absorption in microcrystalline silicon films and solar cells is mainly due to a longer optical path as the result of an efficient diffuse light scattering at the textured film surface. This light scattering effect is a key characteristic of efficient thin-film-silicon solar cells.

Absorption losses at a nanorough silver back reflector of a solar cell were measured with high accuracy by photothermal deflection spectroscopy. Roughness was characterized by atomic force microscopy. The observed increase of absorption, compared to the smooth silver, was explained by the surface plasmon absorption. Two series of silver back reflectors ͑one covered with thin ZnO layer͒ were investigated and their absorption related to surface morphology.

The spectral dependence of the optical absorption coefficient in thin films of hydrogenated microcrystalline silicon is measured over nine orders of magnitude in the subgap, defect-connected region, and in the above-the-band gap region. Transmittance, reflectance, and constant photocurrent method measurements are combined with Fourier-transform photocurrent spectroscopy (FTPS). Results are analyzed and interpreted as due to electron transitions from defects or interband electron transitions, all having direct relevance to the thin-film microcrystalline silicon solar cell performance. FTPS is a fast and sensitive quantitative method for quality assessment of microcrystalline silicon absorber in solar cells and can be used for quality monitoring in solar cell production.

We present an optical model for thin-film silicon solar cells (both single and multijunction) with nanorough surfaces/interfaces. For these cells, the optical absorptance within each layer and the total reflectance are computed taking into account roughness, angular distribution of scattered light, thicknesses, and optical constants of all layers. In the model, we combine coherent approach, scattering theory, and Monte Carlo tracing method. Results of the model are shown to be in good agreement with the experimentally measured spectral response and the total reflectance of solar cells. Some predictions of the ultimate solar cell performance based on the model are presented as well.

We report on the experimental realization of amorphous/microcrystalline silicon tandem solar cells (Micromorph) based on our three-dimensional design. An enhancement is reached in the short-circuit current by 40%, with an excellent open-circuit voltage of 1.41V and a fill factor of 72%. We have used nanoholes or microholes dry etched into the ZnO front contact layer. Monte Carlo optical modeling shows that stable efficiency of amorphous silicon p-i-n solar cells in over 12% range is possible. For the Micromorph cells, efficiency over 15% with the thickness of amorphous Si below 200 nm and of microcrystalline Si around 500 nm is possible.

Direct measurement of the deep defect density in thin amorphous silicon films with the help of the ‘‘absolute’’ constant photocurrent method is demonstrated here. We describe in detail how the optical (photocurrent) absorption spectrum can be measured directly in absolute units (cm−1) without additional calibration and undisturbed by interference fringes. Computer simulation was performed to demonstrate absolute precision of the measurement and to explain residual interferences which are sometimes observed. The residual interferences are shown to be direct fingerprints of an inhomogeneous defect distribution.

No abstract