No abstract

This contribution deals with the External Sierras and a part of the foreland Ebro Basin related to the southern Pyrenean thrust front. The structure of the External Sierras consists of a south‐verging thrust system developed from middle Eocene to early Miocene times. Since the end of the early Oligocene, a regional‐scale detachment anticline (the Santo Domingo anticline) developed, folding the original thrust system and creating new thrust units. The molassic fill in this part of the Ebro Basin (Uncastillo Formation) mainly corresponds to an extensive, composite distributary fluvial system, termed the Luna system, which drained the uplifted Gavarnie Unit to the north. Small, marginal alluvial fans originated along the External Sierras and coalesced in the proximal‐middle portions of the Luna system. Three tecto‐sedimentary units (TSU), late Oligocene to early Miocene in age, comprise the Uncastillo Formation. Lateral relationships and areal distribution of lithofacies through time have been used to establish sedimentary models for the marginal alluvial fans and the Luna fluvial system. Their sedimentary evolution was controlled by tectonics affecting the drainage basins, and based on mapping and stratigraphic relationships of the TSU, the temporal succession of the marginal alluvial fans and their relationships with each thrust system in the south Pyrenean front can be shown. Alluvial fan formation evolved through time from west to east, in accord with the progressive eastward growth of the Santo Domingo anticline as a conical fold. The fluvial network of the Luna system appears to have been mainly radial, but near the basin margin its architecture was influenced by the syndepositional Fuencalderas and Uncastillo anticlines developed within the Ebro Basin. These low‐amplitude folds originated by layer‐parallel shearing caused by rotation of the southern flank of the Santo Domingo anticline. Progressive uplift of these anticlines constrained part of the fluvial discharge to synclinal areas parallel to the basin margin; these areas where characterized by meandering sandy channels. At the peripheral tips of the anticlines the channel system flowed basinward.

Detailed structural cross‐sections, analysis of extensional structures and palaeotemperatures obtained from primary fluid inclusions in quartz and calcite veins from the extensional Cameros Basin (N Spain) allow an interpretation of its thermal evolution and its geometric reconstruction to be constrained. The Cameros Basin underwent an extensional stage during the Late Jurassic to Early Cretaceous, with a maximum preserved thickness of Mesozoic deposits of about 9000 m. During the Tertiary, the basin was inverted, allowing a large part of the sedimentary sequence to be exposed. Extensional deformation in individual beds created N120E‐striking tension gashes in the synrift sequence, parallel to the master normal faults limiting the basin and dipping perpendicular to bedding. The extensional strain calculated from tension gashes varies between 4 and 12%. The number and thickness of veins increases the lower their position in the stratigraphic section. Palaeotemperatures were obtained from samples along a stratigraphic section comprising a thickness of 4000 m synrift deposits. Homogenization temperatures range from 107 to 225 °C. Palaeothermometric data and geometric reconstruction give a geothermal gradient of 27–41 °C km−1 during the extensional stage and allow an eroded section of at least 1500 m to be inferred. Low‐grade metamorphic assemblages in lutitic rocks of the deepest part of the basin presently exposed at surface imply P–T conditions of 350–400 °C and less than 2 kbar, which implies a geothermal gradient of about 70 °C km−1. Since the metamorphic thermal peak is dated at 100 Ma, the P–T path indicates a heating event during the late Albian, probably linked to the reaching of thermal equilibrium of the continental crust after extension. The results obtained support the hypothesis of a synclinal basin geometry, with vertical superposition of Lower Cretaceous sedimentary units rather than a model of laterally juxtaposed bodies onlapping the prerift sequence.

Permian magmatism in the Pyrenees is characterized by two compositionally different and temporally consecutive magmatic episodes: a calc-alkaline-transitional phase (andesites) and a midly alkaline phase (basalts and dolerites). These two magmatic episodes were related to the attenuation of late Variscan transtensional tectonics and the onset of extension related to regional rifting. The strike-slip fault systems that affected the Pyrenees in late Variscan times initially controlled the development and morphology of the sedimentary basins. These were periodically affected by phases of extension, which controlled the subsidence of the basins, and, in addition, the emplacement of magmas. The whole-rock trace-element and isotopic signature of the andesites suggests that they were derived from the upper mantle and variably hybridized with late orogenic crustal melts, whereas the alkali basalts could have been derived from a lithospheric mantle source, enriched as a consequence of Variscan subduction processes with the contribution, in some areas, of an enriched (asthenospheric) component.

No abstract