Edge radial electric fields were induced in the edge of the TEXTOR tokamak by means of a polarization electrode in order to study their influence on the plasma edge profiles and its confinement. The studies include the generation of H-mode behaviour with either positive or negative polarity. Particle confinement ( T~) of deuterium and of impurity ions as well as energy confinement (73 are investigated. For positive fields which remain below the threshold for the L-H transition, an interesting regime of reduced particle confinement without noticeable energy confinement loss is found. A strong asymmetry in the edge density profiles with respect to the electric field sign is observed at these low polarization voltages. Above the threshold, H-mode behaviour with increased energy confinement and especially particle confinement can be produced with either polarity of the applied electric field. It is, however, found that, whereas the energy confinement in positive H-modes is at least as good as that in negative ones, the ratio T~/ T~ is about three times lower in the former case.

The performance on plasma of the antennas of the proposed ITER ICRF system is evaluated by means of the antenna 24 × 24 impedance matrix provided by the TOPICA code and confirmed and interpreted by the semi-analytical code ANTITER II (summarized in an appendix). From this analysis the following system characteristics can be derived: (1) a roughly constant power capability in the entire 40–55 MHz frequency band with the same maximum voltage in the eight feeding lines is obtained for all the considered heating and current drive phasings on account of the broadbanding effect of service stubs. (2) The power capability of the array significantly depends on the distance of the antenna to the separatrix, the density profile in the scrape-off layer (SOL) and on the strap current toroidal and poloidal phasings. The dependence on phasing is stronger for wider SOL. (3) To exceed a radiated power capability of 20 MW per antenna array in the upper part of the frequency band, with a separatrix–wall distance of 17 cm and a conservative short decay plasma edge density profile, the system voltage stand-off must be 45 kV and well chosen combinations of toroidal and poloidal phasing are needed. (4) On account of the plasma gyrotropy and of poloidal magnetic field, special care must be taken in choosing the optimal toroidal current drive and poloidal phasings. The ANTITER II analysis shows furthermore that important coaxial and surface mode excitation can only be expected in the monopole toroidal phasing, that strong wave reflection from a steep density profile significantly reduces the coupling even if the separatrix is closer to the antenna and that the part of the edge density profile having a density lower than the cut-off density pertaining to the considered phasing does not significantly contribute to the coupling.

We present an ultrafast neural network (NN) model, QLKNN, which predicts core tokamak transport heat and particle fluxes. QLKNN is a surrogate model based on a database of 300 million flux calculations of the quasilinear gyrokinetic transport model QuaLiKiz. The database covers a wide range of realistic tokamak core parameters. Physical features such as the existence of a critical gradient for the onset of turbulent transport were integrated into the neural network training methodology. We have coupled QLKNN to the tokamak modelling framework JINTRAC and rapid control-oriented tokamak transport solver RAPTOR. The coupled frameworks are demonstrated and validated through application to three JET shots covering a representative spread of H-mode operating space, predicting turbulent transport of energy and particles in the plasma core. JINTRAC-QLKNN and RAPTOR-QLKNN are able to accurately reproduce JINTRAC-QuaLiKiz T i,e and n e profiles, but 3 to 5 orders of magnitude faster. Simulations which take hours are reduced down to only a few tens of seconds. The discrepancy in the final source-driven predicted profiles between QLKNN and QuaLiKiz is on the order 1%-15%. Also the dynamic behaviour was well captured by QLKNN, with differences of only 4%-10% compared to JINTRAC-QuaLiKiz observed at mid-radius, for a study of density buildup following the L-H transition. Deployment of neural network surrogate models in multi-physics integrated tokamak modelling is a promising route towards enabling accurate and fast tokamak scenario optimization, Uncertainty Quantification, and control applications.

The main objective of this paper is investigation of methods for reduction of divertor heat loads in order to increase the lifetime of divertor tiles in future fusion reactors. Special emphasis is given to studies of reduction of transient heat loads due to edge localized modes (ELMs). Two methods are compared: argon seeded type-I ELMy H-modes and nitrogen seeded type-III ELMy H-modes. In both scenarios, the impurity seeding leads to a reduction in the pedestal energy and hence a reduction in the energy released by the ELM. This consequentially reduces the power load to the divertor targets. At high radiative power fractions in type-III ELMy H-modes, part of that released ELM energy (small ELMs, below 20 kJ) is dissipated by radiation in the scrape off layer (SOL). Modelling of the ELM mitigation supports the experimental findings. This ELM mitigation by radiative dissipation is not effective for larger ELMs. In between ELMs, the plasma is detached and radiates strongly from the X-point region. During an ELM, the nitrogen in the X-point and divertor region becomes ionized into more weakly radiating higher charge states and the plasma re-attaches for large ELMs. At JET, argon radiates predominantly in the main plasma and not so much in the cold divertor region. Hence, the effect of radiative dissipation of ELM heat fluxes by argon is very low due to the limited argon density in the divertor region. Nevertheless, both scenarios might be compatible with an integrated ITER scenario, with respect to acceptable divertor lifetime and acceptable confinement.

Impurity injection in the JET ELMy H-mode regime has produced high-confinement, quasi-steady-state plasmas with densities close to the Greenwald density. However, at large Ar densities, a sudden loss of confinement is observed. A possible correlation between loss of confinement and the observed MHD phenomena, both in the core and in the edge of the plasma, was considered. The degradation in confinement coincided with impurity profile peaking following the disappearance of sawtooth activity. In addition, impurity density profile analysis confirmed that central MHD modes prevented impurity peaking. Experiments were designed to understand the role of sawtooth crashes in redistributing impurities. Ion-cyclotron radio frequency heating was used to control the central q-profile and maintain sawtooth activity. This resulted in quasi-steady-state, high-performance plasmas with high Ar densities. At H 98y * f GWD ∼ 0.8 and high Ar injection rates, quasi-steady-states, which previously only lasted <1τ E , were now maintained for the duration of the heating (t ∼ 9τ E). The increased central heating may have an additional beneficial effect in opposing impurity accumulation by changing the core power balance and modifying the impurity transport as predicted by neo-classical theory.