No abstract

No abstract

No abstract

Thermogravimetric experiments were carried out for a few types of wood with determination of the kinetic parameters characterizing the pyrolysis process. In the present work the various kinetic models used for this purpose are suggested. Analyzing software tool for calculation of thermal conversion products and reactor balance is developed. The optimal temperature range for biomass pyrolysis is identified using this tool. The influence of steam and air flow rates on the gasification products is represented. The impact of operating parameters on the synthesis gas composition was evaluated. Comparison of the computational model and the results obtained during experimental studies on the existing gasifier were carried out. The combined cycle power plant involving the biomass gasification process has been numerically simulated in the Aspen Plus. Calculations of the optimal operating parameters of different thermal process components and of the entire combined cycle power plant system were performed.

No abstract

No abstract

No abstract

The hydrogen-donor abilities of polymers and the activity of catalysts in the process of thermal destruction of the organic mass of primary coal tar (PCT) are studied by non-isothermal kinetics methods. PCT,magnetic microspheres, nickel-deposited chrysotilechrysotile and Fe3O4nanocatalysts were used as initial raw materials. Рolymers such as polyethylene (PE), polystyrene(PS) and polyethylene glycol (PEG) were selected as a hy-drogen donor. The phases Mg3[OH]4{Si2O5} and NiO were determined by X-ray phase analysis (XRD) in the obtained catalyst (nickel-deposited chrysotile), and the presence of highly dispersed nickel oxide particles on the surface and inside the nanotubes was shown by the transmission electron microscope (TEM). Nickel oxide particles of 8–11 nmand 30–37 nmwere evenly distributed on the surface and inside the chrysotile nanotubes. The kinetic parameters of the thermal destruction of a mixture of PCT, catalyst and polymer material were determined on the basis of thermogravimetric analysis using the integral method and the method for determin-ing the thermokinetic parameters by the inflection point on the thermogravimetric curve(TG). The change in the activation energy, rate constant and pre-exponential factor with an increase in the degree of destruction of the organic mass of the PCT is established. It was shown that the nature of polymers and catalysts significantly affects the value of the rate constant and the activation energy. The calculated activation energies of the thermal destruction of a mixture of coal tar with PS and PE in the presence of a catalyst (nickel-deposited chrysotile) by the first method are 47.6 kJ/mol and 40.4 kJ/mol, and by the second method are 47.3 kJ/mol and 86.5kJ/mol respectively.