Equipping new-generation nuclear power plants with passive means for controlling unanticipated accidents is one of the most promising directions for increasing safety, which is being implemented in the AES-2006 design for the site of the Leningradskaya nuclear power plant. An urgent problem is to obtain experimental validation of the passive system for removing heat from the protective envelope during unanticipated accidents with loss of coolant from the first loop in the case where the active systems fail. A particularity of the system is its state of constant readiness. The system functions with natural circulation of the coolant in both loops. Considering the importance of the passive heat removal system for ensuring the localizing properties of the protective envelope, OKBM Afrikantov has developed a large-scale stand and performed experimental investigations on validation of the effectiveness and serviceability of the cooling loop of a passive system for removing heat from the protective envelope.One direction for increasing the safety of nuclear power plants is to adopt passive systems which guarantee that the required functions will be executed during a loss of all electric power sources at a plant. This increases the stability of the nuclear facility with respect to not only the failure of power supplies but also possible extreme actions. The AES-2006 design of the safety systems for the site of the Leningradskaya nuclear power plant provides active as well as passive systems which do not require power sources to operate. These systems include a passive system for removing heat from the protective envelope during accidents with loss of coolant in the first loop and failure of active safety systems. During normal operation of a nuclear power plant, the system is in a state of constant readiness. During accidents in which steam enters the protective envelope and the temperature inside the envelope increases, heat is removed to exchanger-condensers by natural convection and condensation. Natural circulation of coolant arises in the cooling loop of the passive heat removal system; heat is removed to the final absorber into the atmosphere.When such systems are being designed, there arise problems due to the low hydrodynamic stability of the flow of boiling coolant in the cooling loop of the passive heat removal system under low pressure. Computational and experimental
The Article contains the results of the study performed for the samples made from alloys PT-7М, 42ХНМ, Inconel 690, Incoloy 800 for resistance against hot salt corrosion in the mixture of crystallized NaCl and KBr salts, in ratio 300:1 by weight, and in the temperature range from 150 °С to 300 °С, both in contact with the air and in a leak-tight autoclave in the atmosphere of saturated water steam. Regularities of hot salt corrosion behavior in the alloys under the study were detected under testing conditions. The atmosphere of saturated water steam inhibits development of halt salt corrosion of alloy ПТ-7М in the entire temperature range of the testing.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.