In this study we calibrate and validate in situ ionospheric electron density (Ne) and temperature (Te) measured with Langmuir probes (LPs) on the three Swarm satellites orbiting the Earth in circular, nearly polar orbits at ~500 km altitude. We assess the accuracy and reliability of the LP data (December 2013 to June 2016) by using nearly coincident measurements from low‐ and middle‐latitude incoherent scatter radars (ISRs), low‐latitude ionosondes, and Constellation Observing System for Meteorology, Ionosphere, and Climate (COSMIC) satellites, covering all latitudes. The comparison results for plasma frequency ( f∝Ne) for each Swarm satellite are consistent across these three, principally different measurement techniques. It shows that the Swarm LPs systematically underestimate plasma frequency by about 10% (0.5–0.6 MHz). The correlation coefficients are high (≥0.97), indicating accurate relative variation in the Swarm LP densities. The comparison of Te from high‐gain LPs and those from ISRs reveals that all three satellites overestimate it by 300–400 K but exhibit high correlations (0.92–0.97) against the validation data. The low‐gain LP Te data show larger overestimation (~700 K) and lower correlation (0.86–0.90). The adjustment of the Swarm LP data based on Swarm‐ISR comparison results removes the systematic biases in the Swarm data and gives plasma frequencies and high‐ and low‐gain electron temperatures that are precise within about 0.4 MHz (8%), 150–230 K, and 260–360 K, respectively. We demonstrate that the applied correction significantly improves the agreement between (1) the plasma densities from Swarm, and from ionosondes and COSMIC, and (2) the Te from Swarm LPs and International Reference Ionosphere 2016.

High‐latitude ionospheric plasma convection plays a fundamental role in determining many processes in the terrestrial ionosphere. Electric Field Instruments on the European Space Agency's three polar‐orbiting Swarm satellites measure ionospheric ion drift velocities at about 500 km altitude using thermal ion imager energy/angle‐of‐arrival electrostatic analyzers. Recently, European Space Agency released horizontal cross‐track components of these drifts, calibrated at high latitudes. This paper concerns the validation of the Swarm horizontal cross‐track ion drift measurements. All available Swarm‐A and Swarm‐B 2 Hz data between November 2015 and July 2017 were used and the climatology of high‐latitude ion convection was constructed and examined. Results were compared to corresponding climatology obtained from the Weimer 2005 empirical convection electric field model under different interplanetary magnetic field and solar wind conditions in the northern and southern hemispheres, separately. The ion drift data sometimes exhibit large offsets at middle latitudes. However, following a recalibration of the drifts using a refinement of the offset removal, the Swarm cross‐track ion drift climatology agrees reasonably well statistically with the Weimer 2005 model, and properly responds to the changing geospace environment. The two results agree within about 200 m/s (root‐mean‐square deviation), however the correlations are higher for southward interplanetary magnetic field and in the northern hemisphere (rswarm‐A = 0.84, rswarm‐B = 0.77), for which the corresponding magnitudes of Swarm‐A and Swarm‐B drifts are ~14% and ~33% larger than the model estimates, respectively. The convection patterns seen in the revised Swarm horizontal cross‐track drift velocities are more structured than those obtained using the model, but overall no significant systematic errors are present.

No abstract

The HVL and kVp are sufficient for characterizing a kV x-ray source spectrum for accurate dose computation. As these parameters can be easily and accurately measured, they provide for a clinically feasible approach to characterizing a kV energy spectrum to be used for patient specific x-ray dose computations. Furthermore, these results provide experimental validation of our novel hybrid dose computation algorithm.

The voxel-based hybrid method evaluates the LBTE rapidly and accurately to estimate the absorbed x-ray dose at any POI or series of POIs from a kV imaging procedure.