Silicon detectors with a fine segmentation (micropixel and microstrip) are the main type of detectors used in the inner trackers of Large Hadron Collider (LHC) experiments. Due to the high luminosity of the LHC machines they are required to have a fast response to fit the short shaping time of 20 ns and to be radiation hard. Evaluation of silicon microstrip detectors developed for the ATLAS silicon tracker and carried out under collaboration of CERN and Ioffe Physico-Technical Institute has shown the reversal of the pulse polarity in the detector response to short-range radiation. Since the negative signal is of about 30%-60% of the maximal positive one, the effect strongly reduces the charge collection efficiency even in nonirradiated detectors. The investigation presents the consideration of the origin of a negative response in Si microstrip detectors and the experimental proof of the model. The study of the effect has been carried out using "baby" strip detectors with a special design: each strip has a window in a metallization, which covers the + implant. The scan of a laser across the strips clearly shows that the negative response is observed along the scan in the interstrip gap. As soon as the light spot is placed on the strip + implant the negative response disappears and the value of the charge collected by the active strip proportionally increases. A phenomenological model considers the origin of the negative response as the effect of carrier trapping at the Si-SiO 2 interface between the strips.
Abstract-Silicon detectors for the Roman Pots of the the large hadron collider TOTEM experiment aim for full sensitivity at the edge where a terminating structure is required for electrical stability. This work provides an innovative approach reducing the conventional width of the terminating structure to less than 100 m, still using standard planar fabrication technology. The objective of this new development is to decouple the electric behavior of the surface from the sensitive volume within a few tens of micrometers. The explanation of the basic principle of this new approach together with the experimental confirmation via electric measurements and beam test are presented in this paper, demonstrating that silicon detectors with this new terminating structure are fully operational and efficient to under 60 m from the die cut.
The TOTEM experiment will detect leading protons scattered in angles of microradians from the interaction point at the Large Hadron Collider. This will be achieved using detectors with a minimized dead area at the edge. The collaboration has developed an innovative structure at the detector edge reducing the conventional dead width to less than 100 μm, still using standard planar fabrication technology. In this new development, the current of the surface is decoupled from the sensitive volume current within a few tens of micrometers. The basic working principle is explained in this paper. Final size detectors have been produced using this approach. The current-voltage and current-temperature characteristics of the detectors were studied and the detectors were successfully tested in a coasting beam experiment.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.