No abstract

At the central column of ASDEX Upgrade, an area of 5.5 m 2 of graphite tiles was replaced by tungsten-coated tiles representing about two-thirds of the total area of the central column. No negative influence on the plasma performance was found, except for internal transport barrier limiter discharges. The tungsten influx W stayed below the detection limit only during direct plasma wall contact or for reduced clearance in divertor discharges spectroscopic evidence for W could be found. From these observations a penetration factor of the order of 1% and effective sputtering yields of about 10 −3 could be derived, pointing to a strong contribution by light intrinsic impurities to the total W-sputtering. The tungsten concentrations ranged from below 10 −6 up to a few times 10 −5 . Generally, in discharges with increased density peaking, a tendency for increased central tungsten concentrations or even accumulation was observed. Central heating (mostly) by ECRH led to a strong reduction of the central impurity content, accompanied by a very benign reduction of the energy confinement. The observations suggest that the W-source strength plays only an inferior role for the central W-content compared to the transport, since in the discharges with increased W-concentration neither an increase in the W-influx nor a change in the edge parameters was observed. In contrast, there is strong experimental evidence, that the central impurity concentration can be controlled externally by central heating.

Recent experiments at ASDEX Upgrade have achieved advanced scenarios with high β N (>3) and confinement enhancement over ITER98(y, 2) scaling, H H98y2 = 1.1-1.5, in steady state. These discharges have been obtained in a modified divertor configuration for ASDEX Upgrade, allowing operation at higher triangularity, and with a changed neutral beam injection (NBI) system, for a more tangential, off-axis beam deposition. The figure of merit, β N H ITER89-P , reaches up to 7.5 for several seconds in plasmas approaching stationary conditions. These advanced tokamak discharges have low magnetic shear in the centre, with q on-axis near 1, and edge safety factor, q 95 in the range 3.3-4.5. This q-profile is sustained by the bootstrap current, NBI-driven current and fishbone activity in the core. The off-axis heating leads to a strong peaking of the density profile and impurity accumulation in the core. This can be avoided by adding some central heating from ion cyclotron resonance heating or electron cyclotron resonance heating, since the temperature profiles are stiff in this advanced scenario (no internal transport barrier). Using a combination of NBI and gas fuelling line, average densities up to 80-90% of the Greenwald density are achieved, maintaining good confinement. The best integrated results in terms of confinement, stability and ability to operate at high density are obtained in highly shaped configurations, near double null, with δ = 0.43. At the highest densities, a strong reduction of the edge localized mode activity similar to type II activity is observed, providing a steady power load on the divertor, in the range of 6 MW m −2 , despite the high input power used (>10 MW).

No abstract