No abstract

No abstract

The aim of the present study is to determine the deoxyribonucleic acid (DNA) damage by cells exposed to atmospheric pressure non-thermal plasma (APNTP). Mouse leukocytes embedded in agarose were exposed to the plasma at two different distances from a helium plasma needle outlet and during three different exposure periods. Damage was assessed by the single cell gel electrophoresis assay. The results indicate that, at 0.1 cm from the plasma needle, the exposure caused complete DNA fragmentation determined by the presence of so called "clouds". Samples exposed at 0.5 cm from the slide sample surface presented damage proportional to the exposure periods in terms of tail intensity, tail moment and "clouds" frequency. Studies performed with alkaline single cell gel electrophoresis assay to determine DNA breaks and alkali-labile sites, indicates that DNA damage produced by exposure to APNTP was caused mainly by oxidative radicals, rather than by UV light which causes cyclobutane pyrimidine dimers. These results allow us to conclude that plasma needle induced DNA breaks in mice leukocytes proportionally to exposure time.

No abstract

No abstract

Plasma immersion ion implantation (PIII) of stainless steels with nitrogen has been successfully used for surface hardening purposes. This process has been carried out inside a toroidal discharge chamber in a DC/RF plasma. The RF plasma was created by one antenna located inside the chamber, diametrically opposite to the DC electrode. The latter is polarized with 1 kV and then the discharge is controlled by varying the gas pressure before the RF signal is applied. The main plasma parameters were established by means of double electric probes yielding electron temperature values within 0.5-1.5 eV and density values within 1.5×1015 to 4×10 15 m −3 for the DC case while 1.5-3.0 eV and 7×10 14 to 3×10 15 m −3 were reached with RF assisted DC. We present in this work the experimental results obtained from a PIII process applied to AISI 304 stainless steel plates. The outcome shows that the Vickers hardness has been incremented according to the gas pressure within the 1×10 −1 to 1×10 −3 mbar range. The treated plates were analyzed by scanning electron microscopy (SEM) and the results point to an increased percentage of nitrogen, around 20%. By means of x-ray diffractometry (XRD) the gamma expanded phase and compounds such as Fe3NiN, Ni4N, FeNiN and Fe3N were determined.

An experimental study of ATCC (American Type Culture Collection) 8739 Escherichia coli bacteria inactivation in water by means of pulsed dielectric barrier discharge (PDBD) atmospheric pressure plasmas is presented. Plasma is generated by an adjustable power source capable of supplying high voltage 25 kV pulses, ∼30 μs long and at a 500 Hz frequency. The process was conducted in a ∼152 cm 3 cylindrical stainless steel coaxial reactor, endowed with a straight central electrode and a gas inlet. The bacterial concentration in water was varied from 10 3 up to 10 8 E. coli cells per millilitre.The inactivation was achieved without gas flow in the order of 82% at 10 8 colony-forming units per millilitre (CFU mL -1 ) concentrations in 600 s. In addition, oxygen was added to the gas supply in order to increase the ozone content in the process, raising the inactivation percentage to the order of 90% in the same treatment time. In order to reach a higher efficiency however, oxygen injection modulation is applied, leading to inactivation percentages above 99.99%. These results are similarly valid for lower bacterial concentrations.

One alternative application in the decomposition and destruction of volatile organic compounds (VOCs) by a silent plasma dielectric barrier discharge (DBD) has been successfully accomplished. For this purpose, we have designed and constructed two pairs of cells, of rectangular and circular geometries, 333.96 cm 3 each cell, and a similar second pair of 62.25 cm 3 each one. Resonant inverters for low (3.3 kHz) and high (100 kHz) frequencies were also designed and applied to these cells. The specification of the main physical parameters of each cell contemplates: i) a first order degradation ratio of the compound, and ii) air breakdown at atmospheric pressure as a function of the carrying gas. The power consumed by the cells during the discharges was computed both theoretically and experimentally by Manley's method. The equipment was applied to the degradation of toluene, which has been degraded by an oxidation process in air-oxygen and argon-oxygen gas mixtures at atmospheric pressure within the cells. The destruction efficiency was measured as a function of the initial concentration. When air is used as an oxidant, a clear formation of solid products on the walls of dielectric glass plates has been observed, such deposits being polymeric in nature. These deposits seem to be responsible for a decline in the degradation efficiency of the treated compounds.