Wireless Full-Duplex Medium Access Control for Enhancing Energy Efficiency

Kobayashi, Makoto; Murakami, Ryo; Kizaki, Kazuhiro; Saruwatari, Shunsuke; Watanabe, Takashi

doi:10.1109/tgcn.2017.2756883

Cited by 10 publications

(6 citation statements)

References 23 publications

(5 reference statements)

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The calculated power consumption values for ω TX , ω RX , and ω d in TABLE 3 are based on [45]. Values of ω SIC and ω CTRL are stated in [46]. While ω SIC accounts for both active and passive cancellation circuits, the majority of SIC is treated passively with minimal power consumption.…”

Section: Results and Evaluationmentioning

confidence: 99%

See 1 more Smart Citation

Performance Analysis and Enhancements for In-Band Full-Duplex Wireless Local Area Networks

Murad

Eltawil

2020

IEEE Access

View full text Add to dashboard Cite

In-Band Full-Duplex (IBFD) is a technique that enables a wireless node to simultaneously transmit a signal and receive another on the same frequency band. Thus, IBFD wireless systems can theoretically provide up to twice the channel capacity compared to conventional Half-Duplex (HD) systems. In order to study the feasibility of IBFD networks, reliable models are needed to capture anticipated benefits of IBFD above the physical layer (PHY). In this paper, an accurate analytical model based on Discrete-Time Markov Chain (DTMC) analysis for IEEE 802.11 Distributed Coordination Function (DCF) with IBFD capabilities is proposed. The model captures all parameters necessary to calculate important performance metrics which quantify enhancements introduced as a result of IBFD solutions. Additionally, two frame aggregation schemes for Wireless Local Area Networks (WLANs) with IBFD features are proposed to increase the efficiency of data transmission. Matching analytical and simulation results with less than 1% average errors confirm that the proposed frame aggregation schemes further improve the overall throughput by up to 24% and reduce latency by up to 47% in practical IBFD-WLANs. More importantly, the results assert that IBFD transmission can only reduce latency to a suboptimal point in WLANs, but frame aggregation is necessary to minimize it. Finally, energy-efficiency is compared for both HD and IBFD networks. In comparison with the HD counterpart, IBFD systems can deliver superior energy efficiency for a given traffic scenario at the cost a higher power consumption.

show abstract

Section: Results and Evaluationmentioning

confidence: 99%

“…Fig. 10 shows analytical and simulation results of energyefficiency in terms of Megabits/Joule resulting from dividing throughput by consumed power as in [46]. The results are reported for both HD and IBFD cases.…”

Section: Random ρ Valuesmentioning

confidence: 99%

Performance Analysis and Enhancements for In-Band Full-Duplex Wireless Local Area Networks

Murad

Eltawil

2020

IEEE Access

View full text Add to dashboard Cite

show abstract

“…In Figure 10, the loop signal shown in Figure 9 is canceled by equipping the SD-RoF edge with the analog cancellator shown in Figure 11. We used the passive cancellation circuit developed in [25] for full-duplex wireless communication as the analog cancellator.…”

Section: F Analog Cancellatormentioning

confidence: 99%

Design and Prototype Implementation of Software-Defined Radio Over Fiber

et al. 2021

Self Cite

View full text Add to dashboard Cite

Future networks require a high degree of flexibility over wide areas to enable many services that require higher quality wireless networks such as remote control of cars and remote surgery. Therefore, the network technology must combine high capacity, low latency, and flexibility. To deal with these requirements, we developed Software-Defined Radio over Fiber (SD-RoF), which is an architecture that tightly couples light and radio at a low cost. SD-RoF offers the following two key features: elastic wireless service and elastic bidirectional passthrough. The elastic wireless service provides users with access to wireless services that they need at any time in any place. The elastic bidirectional passthrough connects two remotely located points via RoF through radio waves and enables allowing for bidirectional radio communication between devices at each location. In this study, we design and prototype implementation of SD-RoF, and conduct a basic evaluation of the implemented circuit and demonstration experiments on elastic bidirectional passthrough. Through demonstration experiments, we found the feasibility and the challenges of SD-RoF. In addition, the deployment of SD-RoF, application scenarios, and operational issues are discussed.

show abstract

“…The network throughput could be improved by Asymmetrical Duplex MAC protocol. It would establish dual link between half duplex clients and full duplex access point [26]. All these improvements in MAC layer technologies are predicted to bring large paradigm shift in the communication industry.…”

Section: Alternate Technologiesmentioning

confidence: 99%

A short survey on next generation 5G wireless networks

Yildiz

Džakmić

2019

Sustainable Engineering and Innovation

View full text Add to dashboard Cite

Current 4G - the fourth-generation wireless communication, which exists in most countries represents an advance of the previous 3 generation wireless communication. However, there are some challenges and limitations, associated with an explosion of wireless devices, which cannot be accommodated by 4G. Increasing the proliferation of smart devices, the development of new multimedia applications and growing demand for high data rates are among the main problems of the existing 4G system. As a solution, the wireless system designers have started research on the fifth-generation wireless systems. 5G will be the paradigm shift that could provide with ultra-high data rate, low latency, increase of the base station capacity and improved quality of services. This paper will be the review of the changes through the evolution of existing cellular networks toward 5G. There will be represented a comprehensive study associated with 5G, requirements for 5G, its advantages, and challenges. We will explain the architecture changes – radio access network (RAN), air interfaces, smart antennas, cloud RAN and HetNet. Furthermore, there will be discussed about physical layer technologies, which include new channel modes estimation, new antenna design, and MIMO technologies. Also, we will discuss the MAC layer protocols. We will look at three kinds of technologies: heterogeneous networks, massive multiple-input, and output, millimeter-wave. Finally, there will be explained the applications, supported by 5G, new features, various possibilities, and predictions.

show abstract

Wireless Full-Duplex Medium Access Control for Enhancing Energy Efficiency

Cited by 10 publications

References 23 publications

Performance Analysis and Enhancements for In-Band Full-Duplex Wireless Local Area Networks

Performance Analysis and Enhancements for In-Band Full-Duplex Wireless Local Area Networks

Design and Prototype Implementation of Software-Defined Radio Over Fiber

A short survey on next generation 5G wireless networks

Contact Info

Product

Resources

About