Full-duplex systems are expected to double the spectral efficiency compared to conventional halfduplex systems if the self-interference signal can be significantly mitigated. Digital cancellation is one of the lowest complexity self-interference cancellation techniques in full-duplex systems. However, its mitigation capability is very limited, mainly due to transmitter and receiver circuit's impairments. In this paper, we propose a novel digital self-interference cancellation technique for full-duplex systems. The proposed technique is shown to significantly mitigate the self-interference signal as well as the associated transmitter and receiver impairments. In the proposed technique, an auxiliary receiver chain is used to obtain a digital-domain copy of the transmitted Radio Frequency (RF) self-interference signal. The selfinterference copy is then used in the digital-domain to cancel out both the self-interference signal and the associated impairments. Furthermore, to alleviate the receiver phase noise effect, a common oscillator is shared between the auxiliary and ordinary receiver chains. A thorough analytical and numerical analysis for the effect of the transmitter and receiver impairments on the cancellation capability of the proposed technique is presented. Finally, the overall performance is numerically investigated showing that using the proposed technique, the self-interference signal could be mitigated to ∼3dB higher than the receiver noise floor, which results in up to 76% rate improvement compared to conventional half-duplex systems at 20dBm transmit power values. Index TermsFull-duplex systems, digital self-interference cancellation, transceiver nonlinearities, phase noise.

No abstract

In this paper, we analytically study the regime in which practical full-duplex systems can achieve larger rates than an equivalent half-duplex systems. The key challenge in practical full-duplex systems is uncancelled self-interference signal, which is caused by a combination of hardware and implementation imperfections. Thus, we first present a signal model which captures the effect of significant impairments such as oscillator phase noise, low-noise amplifier noise figure, mixer noise, and analog-to-digital converter quantization noise. Using the detailed signal model, we study the rate gain region, which is defined as the region of received signal-of-interest signal strength where full-duplex systems outperform half-duplex systems in terms of achievable rate. The rate gain region is derived as a piecewise linear approximation in log-domain, and numerical results show that the approximation closely matches the exact region. Our analysis shows that when phase noise dominates mixer and quantization noise, fullduplex systems can use either active analog cancellation or baseband digital cancellation to achieve near-identical rate gain regions. Finally, as a design example, we numerically investigate the full- Index TermsFull-duplex, rate gain, radio impairments, analog self-interference cancellation, digital self-interference cancellation.

No abstract

In full-duplex systems, due to the strong selfinterference signal, system nonlinearities become a significant limiting factor that bounds the possible cancellable self-interference power. In this paper, a self-interference cancellation scheme for full-duplex orthogonal frequency division multiplexing systems is proposed. The proposed scheme increases the amount of cancellable self-interference power by suppressing the distortion caused by the transmitter and receiver nonlinearities. An iterative technique is used to jointly estimate the self-interference channel and the nonlinearity coefficients required to suppress the distortion signal. The performance is numerically investigated showing that the proposed scheme achieves a performance that is less than 0.5dB off the performance of a linear full-duplex system.

Index Terms-Beam-steering, reconfigurable antenna, full-wave analysis, signal to noise ratio.

Abstract-In this paper, we introduce for the first time, a closedform solution for the memristor-based memory sneak paths without using any gating elements. The introduced technique fully eliminates the effect of sneak paths by reading the stored data using multiple access points and evaluating a simple addition/subtraction on the different readings. The new method requires fewer reading steps compared to previously reported techniques, and has a very small impact on the memory density. To verify the underlying theory, the proposed system is simulated using Synopsys HSPICE showing the ability to achieve a 100% sneak-path error-free memory. In addition, the effect of quantization bits on the system performance is studied.

No abstract