Wide band SRR-inspired slot antenna with circular polarization for wireless application

Rahimi, Maryam; Maleki, Mahshid; Soltani, Marjan; Arezomand, Afsaneh Saee; Zarrabi, Ferdows B.

doi:10.1016/j.aeue.2016.06.001

Cited by 35 publications

(25 citation statements)

References 22 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In comparison with our previous research [32,33], in this paper, we show how the split ring produces double negative characteristics, and the antenna shows good axial ratio where we have negative characteristics.…”

Section: Resultsmentioning

confidence: 96%

A Dual Band Slot Antenna for Wireless Applications With Circular Polarization

Pirooj¹,

Naser‐Moghadasi²,

Zarrabi³

et al. 2017

PIER C

Self Cite

View full text Add to dashboard Cite

Abstract-In recently developed wireless communication systems, circular polarization (CP) antennas are used for communication links to reduce the natural loss effect in receivers. Therefore, in this paper, a dual-band microstrip slot antenna based on a parallel split ring resonator with circular and linear polarization which can be used for wireless and WiMAX applications is presented. The final antenna to design is based on inspired split ring resonators (SRR) to achieve circular polarization and compact size and with special parallel form of the SRR and straight feed line. We have achieved higher bandwidth in the requested frequency range with dual-band characteristics. The final antenna has a bi-directional pattern with circular polarization at the range of 2.9-3.65 GHz and bandwidths of 2-3.6 and 3.8-4.8 GHz with VSWR < 2 for WLAN, Bluetooth and radar applications for IEEE WLAN protocol with gain of 5-6 dBi, respectively. The size of the prototype patch antenna is 40×40 mm 2 . It is designed and fabricated on an FR-4 low cost substrate with ε r = 4.4 and a thickness of 1.6 mm. It is simulated using HFSS full wave software. In addition, the experimental results are presented and compared with simulation for VSWR, radiation patterns and axial ratio. The periodic analysis has been used for extracting the metamaterial parameters.

show abstract

Section: Resultsmentioning

confidence: 96%

A Dual Band Slot Antenna for Wireless Applications With Circular Polarization

Pirooj¹,

Naser‐Moghadasi²,

Zarrabi³

et al. 2017

PIER C

Self Cite

View full text Add to dashboard Cite

show abstract

“…The retrieved negative permittivity

([]|, ɛ)

of the SRR ant is publicized in Figure B. It obviously proves that the significance of permittivity

true[ɛ

] is negative …”

Section: Extraction Of Negative Permeabilitymentioning

confidence: 88%

SRR loaded periwinkle flower shaped fractal antenna for multiband applications

Elavarasi

Shanmuganantham

2017

Micro & Optical Tech Letters

View full text Add to dashboard Cite

The split ring resonator (SRR) loaded periwinkle flower (PWF) shaped fractal antenna for multiband applications are presented. The CPW‐Fed antenna consists of SRR, which is fixed on the back side of the FR4 and periwinkle petals which are etched on top of the FR4 i.e., on the circular patch. The periwinkle flower‐shaped irregular fractal patch is erected on the substrate whose dimensions are Ws × Ls × h mm3 and the ground is also modified (MG) to achieve multiple frequency bands covering 3.476 GHz at S‐band, 4.844 GHz at C‐band, 8.3 GHz also 10.28 GHz at X‐band, 17.76 GHz and at Ku‐band. Parametric analysis and measured antenna device results are also presented.

show abstract

“…This antenna behavior is the same as the previous antenna. Here, as mentioned for the previous model, the inductance and capacitance are related to gaps and microstrip lines as shown in Figure A . In this antenna, two types of SRR‐inspired are used for metamaterial loadings.…”

Section: Metamaterials For Circular Polarizationmentioning

confidence: 99%

“…D, The simulated and measured axial ratio. E, The geometry of the antenna while all mentioned dimensions are a = b = 40 mm, c = 8 mm, d = 6 mm, e = 5.8 mm, f = 2 mm, g = 4 mm, h = 13 mm, i = 12 mm, j = 22 mm, and k = 2 mm, with RHCP Z direction and LHCP in −Z direction and maximum gain of 4 dBi and efficiency is up to 90%…”

Section: Metamaterials For Circular Polarizationmentioning

confidence: 99%

Metamaterial loads used in microstrip antenna for circular polarization: Review

Zarrabi

Pirooj

Pedram

2019

Int J RF Microw Comput Aided Eng

Self Cite

View full text Add to dashboard Cite

The metamaterial elements and structures have been noticed for obtaining circular polarization (CP) while developing various procedures. In this paper, we have mentioned some of these cases and compared the metamaterial loads effect on antenna current distribution. We have classified them into four categories. The first case covers patch antenna based on composite right/left‐handed method, where the metamaterial has been used for changing the current distribution in the loop form. The second case has been achieved by radome and metasurface. In the third model, the interaction between feed and metamaterial load has been considered and the last case has been made by the metamaterial load with truncated structure. The metamaterial loading has been modeled based on Nicolson‐Ross or transmission/reflection techniques for extracting the permittivity and permeability. While the microstrip slot antennas are attractive for wider bandwidth, the truncated structure can change the current for achieving CP. Here, we have studied the antenna for wireless and WiMAX applications.

show abstract

Wide band SRR-inspired slot antenna with circular polarization for wireless application

Cited by 35 publications

References 22 publications

A Dual Band Slot Antenna for Wireless Applications With Circular Polarization

A Dual Band Slot Antenna for Wireless Applications With Circular Polarization

SRR loaded periwinkle flower shaped fractal antenna for multiband applications

Metamaterial loads used in microstrip antenna for circular polarization: Review

Contact Info

Product

Resources

About