Wafer-Level Vacuum Packaging of Smart Sensors

Abstract

The reach and impact of the Internet of Things will depend on the availability of low-cost, smart sensors—“low cost” for ubiquitous presence, and “smart” for connectivity and autonomy. By using wafer-level processes not only for the smart sensor fabrication and integration, but also for packaging, we can further greatly reduce the cost of sensor components and systems as well as further decrease their size and weight. This paper reviews the state-of-the-art in the wafer-level vacuum packaging technology of smart sensors. We describe the processes needed to create the wafer-scale vacuum microchambers, focusing on approaches that involve metal seals and that are compatible with the thermal budget of complementary metal-oxide semiconductor (CMOS) integrated circuits. We review choices of seal materials and structures that are available to a device designer, and present techniques used for the fabrication of metal seals on device and window wafers. We also analyze the deposition and activation of thin film getters needed to maintain vacuum in the ultra-small chambers, and the wafer-to-wafer bonding processes that form the hermetic seal. We discuss inherent trade-offs and challenges of each seal material set and the corresponding bonding processes. Finally, we identify areas for further research that could help broaden implementations of the wafer-level vacuum packaging technology.

Smart Sensors: Analyzing Efficiency of Smart Sensors in Public Domain

“…Most wearables with heart rate monitors today use a method called Photoplethysmography (PPG) to measure heart rate. [3] PPG is a technical term for shining light into skin and measuring amount of light that is scattered by blood flow. That's an over simplification, but PPG sensors are based on the fact that light entering body will scatter in a predictable manner as the blood flow dynamics change, such as changes in blood pulse rates (heart rate) or with changes in blood volume (cardiac output).…”

Dielectrics for Terahertz Metasurfaces: Material Selection and Fabrication Techniques

“…Eutectic bonding is a technique employed to permanently bond devices and wafers through the use of intermediate metallic film layers. This has been employed in hermetic or wafer‐level vacuum packaging and fabrication of heat sinks in packaged microelectromechanical systems (MEMS) and smart sensing devices . Unlike other conventional bonding techniques such as fusion, anodic, solder, and adhesive bonding, eutectic binding allows for less stringent conditions such as low temperature, tolerance to surface topology, and surface cleanliness.…”

“…Unlike other conventional bonding techniques such as fusion, anodic, solder, and adhesive bonding, eutectic binding allows for less stringent conditions such as low temperature, tolerance to surface topology, and surface cleanliness. More so, tens of nanometers at the interface of the two materials undergo liquid phase formation and alloying that creates a permanent bond with high mechanical stability …”

Thin Film Encapsulation for RF MEMS in 5G and Modern Telecommunication Systems

“…Wafer-level bonding and thin film encapsulation are the most common wafer-level packaging methods. In the first case, a ring is applied around the switch and a capping wafer is sealed by solder, glass frit, or friction [4,5]. The bonding ring causes a significant increase in the device footprint, and the capping wafer may create a high aspect ratio device.…”