Tool Wear Rate and Surface Integrity Studies in Wire Electric Discharge Machining of NiTiNOL Shape Memory Alloy Using Diffusion Annealed Coated Electrode Materials

Abstract

Electrode material used in wire electric discharge machining (WEDM/wire EDM) plays a vital role in determining the machined component quality. In particular, when machining hard materials like nickel titanium/NiTi (NiTiNOL) shape memory alloy, the quality of electrode material is important as it may have adverse effects on the surface properties of the alloy. Different electrode materials give different performances, as each electrode material is made up of different conductivity, compositions and tensile strength. Therefore, detailed experimental studies have been carried out to understand the effect of diffusion annealed coated wires (X-type and A-type) on NiTiNOL SMA during the wire EDM process. The tool wear rate and surface roughness responses have been studied for both the electrode materials against different wire EDM variables such as pulse time, pause time, wire feed and spark gap set voltage. The impact of these process parameters on the stated output responses has been analyzed and further surface and subsurface analysis of the machined component has been carried out to understand the impact of diffusion annealed electrode materials during the wire EDM process. The investigation reveals that an A-type diffusion annealed coated wire is found to be most suitable in terms of tool wear rate, surface roughness and surface integrity during machining of NiTiNOL shape memory alloy compared to X-type and traditional brass-based electrode materials. Surface topographical properties were studied using confocal microscopic analysis and scanning electron microscope (SEM) with energy-dispersive spectroscopy (EDS) analysis. The subsurface analysis like microhardness and recast layer thickness was also studied for both the wires against different machining conditions.

Parametric investigation of W-EDM factors for machining AM60B conductive biomaterial

“…Its minimal heat generation and non-contact characteristics make it ideal for handling delicate or heat-sensitive objects. When there is no tool wear in the wire electrode, the consistency of machined products is preserved and tool life is increased 9 . Additionally, production is made user-friendly and productive by its automation characteristics.…”

Experimental investigation on WEDM parameters of Ni-rich nitinol plate

“…Ashish Goyal et al [32] studied the influencing process parameters for kerf width and surface roughness on machining NiTi and reported pulse on time is a major influencing factor for both the responses, whereas pulse off time and wire feed shows less influence on roughness. Many researchers studied optimizing the process parameter in WEDM of SMA to enhance the process performance [33][34][35]. The surface roughness and MRR are the important response factors for the quality and overall productivity in WEDM of NiTi shape memory alloy [36][37][38].…”

Parametric Optimization and Influence of Near-Dry WEDM Variables on Nitinol Shape Memory Alloy

“…Numerical control of the wire electrode has made WEDM process to be vastly suitable for creating the complex shape profiles of the workpiece [ 28 , 29 ]. Kulkarni et al [ 30 ] employed WEDM process to study surface integrity aspects for Nitinol SMA. They utilized RSM models to generating the relationship between design variables and responses.…”