Hot gas generators are used as a source of thermal energy for pre-start preparation of motor vehicles in cold climatic conditions. Their wide application is due to the high thermal power and safety. (Research purpose) The research purpose is in determining the possibilities of using thermoelectric modules to reduce the energy consumption of the battery by hot gas generators. (Materials and methods) Authors used research methods based on the application of standard techniques, while the object of research was the power supply system of a thermal energy source. (Results and discussion) Authors conducted research on ways and methods to reduce the electric consumption of a hot gas generator by recuperating thermal energy into electrical energy using thermoelectric generator modules. The thermoelectric converters installed on the heat pipe of the hot gas generator, due to the high temperature difference, will allow to obtain a high value of the electromotive force. Modeling of the nozzle in the software package of the Ansys three-dimensional modeling system showed that part of the heat energy goes through the surface of the heat pipe. The article proposes the use of a nozzle with a thermoelectric converter installed on the outer surface of the cylinder instead of a heat pipe. The article presents the mathematical model of an improved hot gas generator nozzle. (Conclusions) The use of a thermoelectric converter for the utilization of thermal energy and the replacement of energy losses of the battery, which feeds the hot gas generator, will reduce the internal power losses of the battery and increase the technical readiness of automotive equipment. The introduction of a comprehensive heat treatment system, which is intelligently and functionally linked to a remote monitoring system, will significantly increase the service life of the units most exposed to temperature influences.