Surface modification of UHMWPE fibers by means of polyethylene wax grafted maleic anhydride treatment

Abstract

A novel surface modification method for ultrahigh molecular weight polyethylene (UHMWPE) fibers to improve the adhesion with epoxy matrix was demonstrated. Polyethylene wax grafted maleic anhydride (PEW‐g‐MAH) was deposited on the UHMWPE fibers surface by coating method. The changes of surface chemical composition, crystalline structure, mechanical properties of fiber and composite, wettability, surface topography of fibers and adhesion between fiber and epoxy resin before and after finishing were studied, respectively. The Fourier transform infrared spectroscopy spectra proved that some polar groups (MAH) were introduced onto the fiber surface after finishing. The X‐ray diffraction spectra indicated that crystallinity of the fiber was the same before and after finishing. Tensile testing results showed that mechanical properties of the fiber did not change significantly and the tensile strength of 9 wt % PEW‐g‐MAH treated fiber reinforced composite showed about 10.75% enhancement. The water contact angle of the fibers decreased after finishing. A single‐fiber pull out test was applied to evaluate the adhesion of UHMWPE fibers with the epoxy matrix. After treatment with 9 wt % PEW‐g‐MAH, a pull‐out force of 1.304 MPa which is 53.59% higher than that of pristine UNMWPE fibers was achieved. © 2018 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2018, 135, 46555.

In situ fabrication of CuO/UHMWPE nanocomposites and their tribological performance

“…However, UHMWPE also presents some defects such as low surface hardness, poor abrasive wear resistance, low elastic modulus and bending strength, and poor creep resistance . In order to promote the application of UHMWPE under industrial friction conditions, some modifications need to be implemented to improve its mechanical and tribological performance …”

High‐performance fiber‐reinforced composites with a polydopamine/epoxy silane hydrolysis‐condensate bilayer on surface of ultra‐high molecular weight polyethylene fiber

“…39 Another new absorption peak at 1645 cm À1 is attributed to the C=C stretching vibration of indole. 38 The above results indicate that selfpolymerization of dopamine took place on UHMWPE fiber. In Figure 2c, three new absorption peaks are appeared at 1199, 1101, and 1034 cm À1 , which are identified as the Si-CH 2 -R stretch vibration, Si-O-Si stretch vibration and Si-O-C stretch vibration, 35 respectively, and mutually confirmed by the XPS analysis.…”

“…where F max is the max pull-out stress, N is the number of fibers, D is the UHMWPE fiber diameter, and L is the embedded length. 38 The flexural strength test was taken by a universal testing machine (CMT 5254, Shenzhen SANS Testing Machine Co., Ltd, Shenzhen, China) according to ISO 14125. The size of samples was 80 mm  15 mm  4 mm.…”

Surface modification of UHMWPE fibers with chlorination and polydopamine for enhancing the mechanical properties of composites

“…Flexural strength was a significant index to investigate the interface properties of composites. According to the standard of ISO 14125, a universal testing machine was used to test flexural strength with the rate of 2 mm/min, 34 and the size of samples were 80 mm  15 mm  4 mm. Impact strength was the most intuitive manifestation of the bonding performance of composites, which was measured by an Izod impact testing machine PIT501J according to the standard of ASTM D 3029-FA, 24 and the size of sample was 80 mm  10 mm  4 mm.…”