Study of characteristics of wind turbine PMSG with reduced switches count converters

Ahmed, Ashraf; Abdel-Latif, K.M.; Eissa, M.M.; Wasfy, S. M.; Malik, O.P.

doi:10.1109/ccece.2013.6567673

Cited by 12 publications

(4 citation statements)

References 10 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The modeling and simulation study of variable speed PMSG had attracted many researchers. A simulation study of a variable speed PMSG based on wind turbine connected to the grid through two-leg switch BTB converter was presented it [9]. In Reference [10], a close loop control was also used to control the duty cycle of the boost converter for stand-alone system and connected to the network.…”

Section: Maximum Power Coefficient Control Of a Micro Grid-connected ...mentioning

confidence: 99%

Maximum Power Coefficient Control of a Micro Grid-Connected Wind Energy System

Atiyah

Mahdi

Al-Anbarri

2022

JEASD

View full text Add to dashboard Cite

This paper proposed the integration of the wind energy system (WES) with the grid consists of a wind turbine, a permanent magnet synchronous generator (PMSG), a switch-mode rectifier (SMR) and a three-phase voltage source inverter (VSI). Optimal torque control (OTC) method is applied to the converter on the generator side for maximizing the power coefficient under the change in wind speeds. To synchronize the WES with the grid, another controller is applied to keep dc-bus voltage at constant value and to regulate active and reactive power transmitted into a grid. A system of WES connected into a grid is created and tested in the MATLAB/SIMULINK platform version 2019b. Comprehensive simulation results are used to analyze and verify the excellent performance of the suggested two- control strategy on the machine and grid side.

show abstract

Section: Maximum Power Coefficient Control Of a Micro Grid-connected ...mentioning

confidence: 99%

Maximum Power Coefficient Control of a Micro Grid-Connected Wind Energy System

Atiyah

Mahdi

Al-Anbarri

2022

JEASD

View full text Add to dashboard Cite

show abstract

“…Hence, avoiding heat dissipation in the rotor winding and providing higher overall efficiency. Recently the PM SG is gaining lot of attention for WECS due to compact size, higher power density, reduced losses, high reliability and robustness [5], [10].The block diagram of PM SG based wind turbine is shown in Fig. 4 M oreover there is a need of low speed gearless generator, especially for off-shore wind applications, where the geared doubly fed induction generator or induction generator will require regular maintenance due to tearing-wearing in brushes and gear box.…”

Section: Variable Speed Permanent Magnet Synchronous Generatormentioning

confidence: 99%

“…Some commercially available double diodes have all four terminals available so the user can configure them for single-phase split supply use, half a bridge, or three-phase rectifier. M any devices that generate alternating current (some such devices are called alternators) generate three-phase AC [5], [6]. For a three-phase full-wave rectifier with ideal thyristors, the average output voltage is…”

Section: A Diode Rectifiermentioning

confidence: 99%

See 1 more Smart Citation

A Performance of the Grid Connected Permanent Magnet Synchronous Generator

2015

IJAERD

View full text Add to dashboard Cite

-The main purpose of this paper is to develop a wind energy conversion system model to analyze the behavi our of a permanent magnet synchronous generator (PMS G) for variable s peed applicati on. In this work, the MATLAB/Simulink programmi ng and graphical environment has been used to devel op the wi nd energy conversion system modelling and simulation. This modelling includes the wi nd turbine and the PMS G models. Using this simulation tool, the dynamic analysis and performance eval uation has been achieved for a 5.7KW PMS G. All the system components and system response have been observed closely under different wi nd speeds.

show abstract