Studies on cellulose derivatives. Part IV. The configuration of the polyelectrolyte sodium carboxymethyl cellulose in aqueous sodium chloride solutions

Brown, Wyn; Henley, David

doi:10.1002/macp.1964.020790107

Cited by 94 publications

(23 citation statements)

References 42 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The spokelike orientation of the dendritic rods was observed clearly but in part (e.g., see long rods. [102][103][104] It should be recalled that salt effects on the morphologic characteristics of NaHLA single crystals resemble those of NaCMC. 99 However, the morphologic characteristics of NaHLA are different from that of other polysaccharides, NaCMC, 99 NaDSS, 100 and HPC.…”

Section: Polysaccharidesmentioning

confidence: 96%

Drying Patterns of Dispersions and Solutions

Okubo¹

2015

Colloidal Organization

View full text Add to dashboard Cite

Section: Polysaccharidesmentioning

confidence: 96%

Drying Patterns of Dispersions and Solutions

Okubo¹

2015

Colloidal Organization

View full text Add to dashboard Cite

“…[82][83][84][85][86][87] Details about this data can be found in the last report. Table 8 summarizes properties for each data set.…”

Section: Use Of Literature Datamentioning

confidence: 98%

For Stimul-Responsive Polymers with Enhanced Efficiency in Reservoir Recovery Processes

McCormick¹,

Hester²

2003

View full text Add to dashboard Cite

“…The data sets were described and referenced previously. 78,74,76,77 In addition, data collected in our lab for the 10% APTAC copolymer is shown. Experimental data and necessary parameter values are given in Table (III).…”

Section: Polyelectrolyte Solution Theorymentioning

confidence: 99%

For Stimul-Responsive Polymers With Enhanced Efficiency in Reservoir Recovery Processes

McCormick

Hester²

2004

View full text Add to dashboard Cite

This report contains a series of terpolymers containing acrylic acid, methacrylamide and a twin-tailed hydrophobic monomer that were synthesized using micellar polymerization methods. These polymer systems were characterized using light scattering, viscometry, and fluorescence methods. Viscosity studies indicate that increasing the nonpolar character of the hydrophobic monomer (longer chain length or twin tailed vs. single tailed) results in enhanced viscosity in aqueous solutions. The interactions of these polymers with surfactants were investigated. These surfactants include sodium dodecyl sulfate (SDS), cetyl trimethylammonium bromide (CTAB), Triton X-100. Viscosity measurements of DiC 6 AM and DiC 8 AM mixtures indicate little interaction with SDS, gelation with CTAB, and hemimicelle formation followed by polymer hydrophobe solubilization with Triton X-100. The DiC 10 Am terpolymer shows similar interaction behavior with CTAB and Triton X-100. However, the enhanced hydrophobic nature of the DiC 10 polymer allows complex formation with SDS as confirmed by surface tensiometry. Fluorescence measurements performed on a dansyl labeled DiC 10 Am terpolymer in the presence of increasing amounts of each of the surfactant indicate relative interaction strengths to be CTAB>Triton X-100>SDS.A modified model based on Yamakawa-Fujii and Odjik-Skolnick-Fixman theories was found to describe the contribution of electrostatic forces to the excluded volume of a polyelectrolyte in solution. The model was found to be valid for flexible polymer coils in aqueous salt solutions where intermolecular interactions are minimal. The model suggested that a dimensionless group of parameters termed the dimensionless viscosity should be proportional to the dimensionless ratio of solution screening length to polyion charge spacing. Several sets of experimental data from the literature and from our laboratory have been analyzed according to the model and the results suggest that the two dimensionless groups are indeed related by a universal constant. This model has identified the parameters that are important to fluid mobility, thereby revealing methods to enhance solution performance when using polyions solutions as displacing fluids in oil reservoirs. 5 EXECUTIVE SUMMARYTo date, our synthetic research efforts have been focused on the development of stimuli-responsive water-soluble polymers designed for use in enhanced oil recovery (EOR) applications. These model systems are structurally tailored for potential application as viscosifiers and/or mobility control agents for secondary and tertiary EOR methods. The goal of previous synthetic work has been to design novel polymers that exhibit large dilute solution viscosities in the presence of the adverse conditions normally encountered in oil reservoirs (such as high salt concentrations, the presence of multivalent ions, and elevated temperatures). The polymers are also designed to have "triggerable" properties that can be elicited by external stimuli, such as changes in pH and/or sal...

show abstract

Studies on cellulose derivatives. Part IV. The configuration of the polyelectrolyte sodium carboxymethyl cellulose in aqueous sodium chloride solutions

Cited by 94 publications

References 42 publications

Drying Patterns of Dispersions and Solutions

Drying Patterns of Dispersions and Solutions

For Stimul-Responsive Polymers with Enhanced Efficiency in Reservoir Recovery Processes

For Stimul-Responsive Polymers With Enhanced Efficiency in Reservoir Recovery Processes

Contact Info

Product

Resources

About