Structure, Properties, and In Vitro Behavior of Heat-Treated Calcium Sulfate Scaffolds Fabricated by 3D Printing

Abstract

The ability of inkjet-based 3D printing (3DP) to fabricate biocompatible ceramics has made it one of the most favorable techniques to generate bone tissue engineering (BTE) scaffolds. Calcium sulfates exhibit various beneficial characteristics, and they can be used as a promising biomaterial in BTE. However, low mechanical performance caused by the brittle character of ceramic materials is the main weakness of 3DP calcium sulfate scaffolds. Moreover, the presence of certain organic matters in the starting powder and binder solution causes products to have high toxicity levels. A post-processing treatment is usually employed to improve the physical, chemical, and biological behaviors of the printed scaffolds. In this study, the effects of heat treatment on the structural, mechanical, and physical characteristics of 3DP calcium sulfate prototypes were investigated. Different microscopy and spectroscopy methods were employed to characterize the printed prototypes. The in vitro cytotoxicity of the specimens was also evaluated before and after heat treatment. Results showed that the as-printed scaffolds and specimens heat treated at 300°C exhibited severe toxicity in vitro but had almost adequate strength. By contrast, the specimens heat treated in the 500°C–1000°C temperature range, although non-toxic, had insufficient mechanical strength, which was mainly attributed to the exit of the organic binder before 500°C and the absence of sufficient densification below 1000°C. The sintering process was accelerated at temperatures higher than 1000°C, resulting in higher compressive strength and less cytotoxicity. An anhydrous form of calcium sulfate was the only crystalline phase existing in the samples heated at 500°C–1150°C. The formation of calcium oxide caused by partial decomposition of calcium sulfate was observed in the specimens heat treated at temperatures higher than 1200°C. Although considerable improvements in cell viability of heat-treated scaffolds were observed in this study, the mechanical properties were not significantly improved, requiring further investigations. However, the findings of this study give a better insight into the complex nature of the problem in the fabrication of synthetic bone grafts and scaffolds via post-fabrication treatment of 3DP calcium sulfate prototypes.

Bio‐Derived Natural Materials Based Triboelectric Devices for Self‐Powered Ubiquitous Wearable and Implantable Intelligent Devices

“…[61,174,249,[280][281][282][283] However, the fatigue strength of 3D printed objects is usually unsatisfactory due to the porosity and surface roughness of the printed structures, which necessitates the complex and expensive postmanufacturing treatments, e.g., hot isostatic pressing (HIP) and heat treatments, for improving the mechanical strength of 3D printed objects. [249,255,284,285] Moreover, the soft mechanical nature of polymers and biomaterials limits their printability in 3D structures. [61,255,283,286,287] Recent research shows that fiber reinforcement is an effective approach for improving the mechanical properties of the polymers and biomaterials in 3D printing.…”

Liver Tissue Engineering as an Emerging Alternative for Liver Disease Treatment

“…Apart from the chemical properties, pore size, and volume, along with mechanical properties, scaffold design and fabrication methods are the parameters defining the scaffold efficiency, which are reviewed below. 84,85 Liver scaffolds can be fabricated with a wide range of materials, mostly naturally derived or synthetic polymers, due to their intrinsic characteristics. Although employing polymeric materials and fabricating them using engineering methods have a lack of inherent vascular network, attempts have been conducted to retrain the liver network and structure through novel methods and materials.…”

Utility of extracellular matrix powders in tissue engineering

“…6 Stabilization of synthetic powders necessitates the use of binder chemicals which leave toxic UTILITY OF ECM POWDERS IN TISSUE ENGINEERING and acidic residues in the printed construct. 3,54 Bio-ink, however, can be solidified using non-toxic methods.…”