Structure and properties of polyblends of a thermotropic liquid crystalline polymer with an alloy of polyamide‐6 and ABS

Abstract

SYNOPSISThe relationship between the microstructure and corresponding mechanical properties developed during injection molding of blends containing a liquid crystalline polymer (LCP) as the minor component and a n engineering polymer system has been studied. A wholly aromatic copolyester LCP (Vectra A950) was melt blended at different compositions with a thermoplastic matrix consisting of a commercial compatibilized blend of polyamide-6 and ABS (Triax 1180). These blends were prepared under two different sets of injection molding conditions. In the first case, a higher melt temperature, higher barrel temperature, lower injection pressure, lower mold temperature, and shorter residence time in the mold were used during injection molding, as compared with the second case. The mechanical properties of the blends were superior to those of the base polymer. In the second case, the resulting injection-molded specimens had a distinct skin-core morphology where elongated fibrils of LCP constituted the skin layer. The mechanical properties of the blends processed under the second set of processing conditions were superior to those of the first, though the trends in both cases were the same. To study the effects of process variables the 15% LCP blend and the second set of processing conditions were taken as the base. Samples were injection-molded by varying one parameter at a time. It was seen that the properties of the blend were increased by maintaining a lower barrel temperature, greater injection pressure, lower injection speed, higher mold temperature, and a greater residence time in the heated mold. Thus it was found that the processing conditions played a vital role in determining the mechanical properties and morphology of the polyblends. 0 1996 John Wiley 8z Sons, Inc.