Stabilization and phase transformation of CuFe2O4 sintered from simulated copper-laden sludge

Li, Nien Hsun; Lo, Shang Lain; Hu, Ching Yao; Hsieh, Ching Hong; Chen, Ching Lung

doi:10.1016/j.jhazmat.2011.03.089

Cited by 52 publications

(18 citation statements)

References 21 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…It is well known that the CuFe 2 O 4 has good acid-resisting characteristic because of its spinel structure [27]. However, the structure would be destroyed if the pH is too low.…”

Section: Elution Test Of Cufe 2 Omentioning

confidence: 99%

Kinetics and thermodynamics of adsorption for Cd on green manufactured nano-particles

You

Chang

2012

Journal of Hazardous Materials

119

View full text Add to dashboard Cite

“…It is well known that the CuFe 2 O 4 has good acid-resisting characteristic because of its spinel structure [27]. However, the structure would be destroyed if the pH is too low.…”

Section: Elution Test Of Cufe 2 Omentioning

confidence: 99%

Kinetics and thermodynamics of adsorption for Cd on green manufactured nano-particles

You

Chang

2012

Journal of Hazardous Materials

119

View full text Add to dashboard Cite

“…CuFe 2 O 4 is a well-known magnetic material and exhibits excellent chemical stability, good biocompatibility, ecofriendliness, low toxicity, and low cost [20,21]; consequently, it has been used for contaminant adsorption [22].…”

Section: Introductionmentioning

confidence: 99%

Highly enhanced selectivity for the separation of rhenium and molybdenum using amino-functionalized magnetic Cu-ferrites

Yang

Liu

et al. 2015

J Mater Sci

View full text Add to dashboard Cite

An effective method based on magnetic solidphase extraction for the selective recovery of rhenium and molybdenum has been developed using diethylaminefunctionalized magnetic CuFe 2 O 4 (NH 2 @CuFe 2 O 4 ) as adsorbents. Various experimental parameters that could affect the extraction efficiency had been investigated in detail. NH 2 @CuFe 2 O 4 exhibited high adsorption ability and selectivity to ReO À 4 and MoO 2À 4 ; selective separation of ReO À 4 and MoO 2À 4 could be achieved by adjusting pH of the aqueous solution. The ReO À 4 =MoO 2À 4 adsorption reaction was found to be fast, and the adsorption equilibrium was attained within 6.0 min following a pseudo-secondorder model with an observed rate constant (k 2 ) of 0.0215 mgÁg -1 Ámin -1 /0.0496 mgÁg -1 Ámin -1 at 298 K. The adsorption data could be well interpreted by the Langmuir model. The maximum adsorption capacities for ReO À 4 and MoO 2À 4 obtained from the Langmuir model are 41.667 and 62.893 mg g -1 , respectively. The extraction recovery of ReO À 4 =MoO 2À 4 was more than 93 % from Mo-Re simulated industrial leach liquor.

show abstract

“…6,7 It is also mixed with red mud, the mixture of which is calcined at 550°C to produce catalyst for propane oxidation. 8 All these examples show that the electroplating sludge is recyclable.…”

Section: ■ Introductionmentioning

confidence: 99%

Efficient Selective Catalytic Reduction of NO by Novel Carbon-doped Metal Catalysts Made from Electroplating Sludge

Zhang

et al. 2014

Environ. Sci. Technol.

View full text Add to dashboard Cite

Electroplating sludges, once regarded as industrial wastes, are precious resources of various transition metals. This research has thus investigated the recycling of an electroplating sludge as a novel carbon-doped metal (Fe, Ni, Mg, Cu, and Zn) catalyst, which was different from a traditional carbon-supported metal catalyst, for effective NO selective catalytic reduction (SCR). This catalyst removed >99.7% NO at a temperature as low as 300°C. It also removed NO steadily (>99%) with a maximum specific accumulative reduced amount (MSARA) of 3.4 mmol/g. Gas species analyses showed that NO removal was accompanied by evolving N 2 and CO 2 . Moreover, in a wide temperature window, the sludge catalyst showed a higher CO 2 selectivity (>99%) than an activated carbon-supported metal catalyst. Structure characterizations revealed that carbon-doped metal was transformed to metal oxide in the sludge catalyst after the catalytic test, with most carbon (2.33 wt %) being consumed. These observations suggest that NO removal over the sludge catalyst is a typical SCR where metals/metal oxides act as the catalytic center and carbon as the reducing reagent. Therefore, our report probably provides an opportunity for high value-added utilizations of heavy-metal wastes in mitigating atmospheric pollutions.

show abstract

Stabilization and phase transformation of CuFe2O4 sintered from simulated copper-laden sludge

Cited by 52 publications

References 21 publications

Kinetics and thermodynamics of adsorption for Cd on green manufactured nano-particles

Kinetics and thermodynamics of adsorption for Cd on green manufactured nano-particles

Highly enhanced selectivity for the separation of rhenium and molybdenum using amino-functionalized magnetic Cu-ferrites

Efficient Selective Catalytic Reduction of NO by Novel Carbon-doped Metal Catalysts Made from Electroplating Sludge

Contact Info

Product

Resources

About