Some aspects concerning the combination of downsizing with turbocharging, variable compression ratio, and variable intake valve lift

Abstract

The inefficient running of the spark ignition engine at part loads due to the load control method but, mostly, their major weighting in the vehicle's operation time justifies the interest in the technical solutions, which act in this particular operating range. These drawbacks encountered at low part loads are even more amplified when considering larger engines. For instance, it is well known that, at the same engine load, a larger engine is more throttled than a smaller engine; therefore the concerns are the higher pumping work, the lower real compression ratio, and the overall mechanical efficiency, which is also lower. One solution is a reduction in the displacement without affecting the power output. This is what is now commonly known as the downsizing technique.The combination of downsizing and uploading an engine has been known for a long time. However, the conversion, in an acceptable way, of this potential to actual practice is very challenging. On the one hand, the degree of the downsizing is related to the boost pressure. In order to cope with the knocking phenomenon, the downsized high-pressure turbocharged gasoline engine requires a lower volumetric compression ratio that limits the efficiency on part loads. Therefore, the degree of the downsizing has been limited and, thus, the possible fuel consumption reduction has not yet been fully achieved. On the other hand, other problems are encountered when considering a downsized turbocharged gasoline engine: insufficient low-end torque, poor starting performance, and turbo lag.In order to solve these problems an effective combination of the downsized turbocharged gasoline engine with additional technologies is needed. Thus, the paper will present a so-called adaptive thermal engine, which has at the same time a variable compression ratio and a variable intake valve lift. It will then be demonstrated that it is highly suitable for turbocharging, thus resulting in a high downsizing factor.

A comparison between Miller and five-stroke cycles for enabling deeply downsized, highly boosted, spark-ignition engines with ultra expansion

“…Lake et al [2] examined the potential of reducing engine swept volume to meet the future tighter requirement of CO 2 reduction, and they proposed a promising concept, termed lean burn direction injection (LBDI), to control octane requirement while maintaining a high compression ratio (CR). Clenci et al [3] conducted the analysis on the effects of engine downsizing on the fuel economy. In automotive SI engines, the most frequent operations are at partial loads and the load control is usually implemented by using a throttle valve to restrict airflow into cylinders, which results in pumping loss during gas exchange strokes.…”

Idle Operation with Low Intake Valve Lift in a Port Fuel Injected Engine

“…Nevertheless, this gap can be reduced by the use of different technical solutions: lean burn and stratified-charge gasoline direct injection-GDI, variable valve actuation-VVA, variable compression ratio-VCR, Downsizing, Atkinson-Miller cycle, some of them already applied in mass production [1][2][3][4][5][6][7][8][9][10][11].…”

“…For this purpose, an original VVA engine prototype was used. Its VVA mechanism is able to adjust the intake valve lift continuously between minimum and maximum values during engine operation [5,6,11,23], see Figure 1 and Appendix. …”

Knocking Suppression by Stratified Stoichiometric Mixture With Two-Zone Homogeneity in a DISI Engine

“…The variable compression ratio (VCR) is an ideal method to suppress knocking, however, the structural complexity of the VCR significantly increases the cost. [5]. Cooled exhaust gas recirculation (EGR) is another promising method [6,7], but the engine system becomes complicated and the power density will be reduced for the same hardware.…”