Solar PV stand-alone water pumping system employing PMSM drive

Dubey, Menka; Sharma, Shailendra; Saxena, Rakesh

doi:10.1109/sceecs.2014.6804488

Cited by 37 publications

(8 citation statements)

References 10 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Even at different solar irradiations, the water flow rate is maintained and supervised by using a three-phase voltage source inverter (VSI). 43 In a similar work, maximum power required to drive BLDC motor for SPVWPS is obtained using DC-DC Cuk converter. 44 The effectiveness of Cuk converter in continuous conduction mode (CCM) results in constant input and output current that eliminates the need for an additional filter.…”

Section: Power Converter Unit For Spwpsmentioning

confidence: 99%

A review of various components of solar water‐pumping system: Configuration, characteristics, and performance

Muralidhar

Rajasekar

2021

Int Trans Electr Energ Syst

View full text Add to dashboard Cite

Burning fossil fuel like coal, diesel, and so on, for electricity generation is environmentally hazardous and cause increased CO 2 emissions worldwide. To meet the ever-growing energy demand, solar energy remains top and considered to be most promising one that grabbed global attention recently, especially, in the areas of rural electrification and water pumping. Moreover, the solar photovoltaic (PV) system is advantageous and highly preferred. Thus, this paper attempts to review various components of solar-powered water-pumping systems, its configuration, characteristics, and performance. Also, comparison of water-pumping system with and without maximum power point tracking (MPPT), motor and pumps selection based on water flow rate, optimal converter selection, and effective controller performance is studied. Furthermore, PV pumps behavioral study at various geographical locations is also made. Critical analysis on PV water pumping with limitation and suggestions is also highlighted. Hence, it is envisaged that the data presented in this review paper will be useful to the researchers in the selection of suitable PV techniques, pumps, motors, MPPT, and controllers for the effective design, control, and better performance of solar water-pumping system.

show abstract

Section: Power Converter Unit For Spwpsmentioning

confidence: 99%

A review of various components of solar water‐pumping system: Configuration, characteristics, and performance

Muralidhar

Rajasekar

2021

Int Trans Electr Energ Syst

View full text Add to dashboard Cite

show abstract

“…The function of this system is to control the temperature and ventilation [17]. Wind turbine is applying inside the HVAC ducting system and power management system, from air pressure in the ducting system indirectly can be harvested and store energy [18]. HVAC is chosen due to the turbines work best in environments with strong and consistent winds [19].…”

Section: Introductionmentioning

confidence: 99%

Development and analysis of VAWT offgrid in ducting system

Hamzah

Roslan

Malik

et al. 2020

IJPEDS

View full text Add to dashboard Cite

Horizontal Axis Wind Turbine (HAWT) had been widely used in Malaysia, however, research concluded that the power produced is still low which approximately 0.02% from the wind turbine input is. The average wind speed in Penang, Malaysia, is recorded between 1.0 m/s to 2.5 m/s whereby to produce 2.7 kW of power by HAWT, 12.0 m/s of average wind speed is needed. Therefore, the main objective in this project is to develop and analyse the suitability on the Vertical Axis Wind Turbine (VAWT) to be used for power generation with the wind speed in between 0.5 m/s to 3.0 m/s. Ducting system is chosen rather than the open air since commercial buildings used Heat Ventilation Air Conditioning (HVAC) system. Arduino microcontroller and LabVIEW is used as interfaced to setup two types of sensors that is temperature sensor and anemometer.

show abstract

“…Since continual availability of fuel is a major issue, the idea of solar based water pumping system is gaining over the market. Another issue which prevents efficient working or functioning of the PV array is the load matching [5][6]. This paper presents PV energy generator is connected to Cuk converter with P&O based MPPT controller.…”

Section: Introductionmentioning

confidence: 99%

Mathematical Modelling and Implementation of Solar Based Water Pumping System for Irrigation

Kenge*,

Hasija,

Tare

et al. 2020

IJRTE

View full text Add to dashboard Cite

This paper presents mathematical design of solar based irrigation system for water pumping employing MATLAB/Simulink environment. Perturb and observe (P&O) technique, which is an algorithm, is used for obtaining maximum amount of power from the output. The Perturb and Observe MPPT technique is realized on a cuk converter. The performance of PV system is tested at various solar irradiance and temperature of cell. The results confirmed that motor-pump speed, current and power increases on increasing solar insolation. This paper and piece of research will aid system designers in analyzing the performance of the system at various atmospheric condition in rural irrigation.

show abstract

Solar PV stand-alone water pumping system employing PMSM drive

Cited by 37 publications

References 10 publications

A review of various components of solar water‐pumping system: Configuration, characteristics, and performance

A review of various components of solar water‐pumping system: Configuration, characteristics, and performance

Development and analysis of VAWT offgrid in ducting system

Mathematical Modelling and Implementation of Solar Based Water Pumping System for Irrigation

Contact Info

Product

Resources

About