Smoothed Particle Hydrodynamic simulation of hydraulic jump using periodic open boundaries

Abstract:In this paper, we use the parallel open source code parallelSPHysics based on the weakly compressible Smoothed Particle Hydrodynamics (WCSPH) approach to study a spillway flow over stepped stairs. SPH is a robust mesh-free particle modelling technique and has great potential in treating the free surfaces in spillway hydraulics. A laboratory experiment is carried out for the different flow discharges and spillway step geometries. The physical model is constructed from a prototype reservoir dam in the practical field. During the experiment, flow discharge over the weir crest, free surface, velocity and pressure profiles along the spillway are measured. In the present SPH study, a straightforward push-paddle model is used to generate the steady inflow discharge in front of the weir. The parallelSPHysics model is first validated by a documented benchmark case of skimming flow over a stepped spillway. Subsequently, it is used to reproduce a laboratory experiment based on a prototype hydraulic dam project located in Qinghai Province, China. The detailed comparisons are made on the pressure profiles on the steps between the SPH results and experimental data. The energy dissipation features of the flows under different flow conditions are also discussed. It is shown that the pressure on the horizontal face of the steps demonstrates an S-shape, while on the vertical face it is negative on the upper part and positive on the lower part. The energy dissipation efficiency of the spillway could reach nearly 80%.

Section: Introductionsupporting

confidence: 55%

SPHysics Simulation of Experimental Spillway Hydraulics

Ren

Wang

et al. 2017

“…To date, different SPH models have been widely studied and applied in the field of fluid mechanics. Recently, SPH methods have been widely applied in single-phase flows [12][13][14][15], multiphase flows [16][17][18], and diffusion processes between different density flows [19,20]. Compared to the Euler method, the existing Lagrangian SPH method has performed well in simulating the motion characteristic of particles.…”

Section: Smooth Particle Hydrodynamics Methodsmentioning

confidence: 99%

Numerical Simulation of Hydrodynamics and Reaeration over a Stepped Spillway by the SPH Method

Wan

Gualtieri

et al. 2017

Aerated flows are characterized by complex hydrodynamics and mass-transfer processes. As a Lagrangian method, smoothed particle hydrodynamics (SPH) has a significant advantage in tracking the air-water interface in turbulent flows. This paper presents the application of an SPH method to investigate hydrodynamics and reaeration over stepped spillways. In the SPH method, the entrainment of dissolved oxygen (DO) is studied using a multiphase mass transfer SPH method for reaeration. The numerical results are compared with the hydrodynamics data from Chanson and DO data from Cheng. The simulation results show that velocity distribution and the location of free-surface aeration inception agree with the experimental results. Compared with the experimental results, the distribution of DO concentration over the stepped spillway is consistent with the measurement results. The study shows that the two-phase DO mass transfer SPH model is reliable and reasonable for simulating the hydrodynamics characteristics and reaeration process.

“…In Jonsson et al [75], the hydraulic jump was investigated with smoothed particle hydrodynamics, applying a new approach for periodic open boundary conditions. The jump toe oscillated with a frequency in good agreement with experimental findings found in the literature, and the oscillation amplitude increased with Froude number.…”

Section: Numerical Methods With a Lagrangian Approachmentioning

confidence: 99%

Hydraulic Jump: A Brief History and Research Challenges

Padova

Mossa

2021

This paper presents a brief history of the hydraulic jump and a literature review on hydraulic jumps’ experimental and numerical studies. Leonardo da Vinci noticed this phenomenon early on, but it was only later studied by Bidone in 1820. Since the beginning of the 20th century, the hydraulic jump has received a lot of attention following the development of energy dissipater designs and stilling basins. The late 1920s and early 1930s saw many experimental studies researching the surface roller profile and energy dissipation. The study of internal flow features started in the late 1950s. Starting in the 70s, it was believed that the flow of a jump must be analyzed in its actual configuration of air–water mixture, an aspect that cannot be overlooked. Several experimental studies in the late 1980s and 1990s highlighted the existence of oscillating phenomena under specific flow conditions and particularly, a cyclic variation of jump types over long-lasting experiments. The early 2000s saw many experimental studies researching the complex structure of the separated region in very large channels downstream of the lateral shockwaves. Whereas most of the experiments provide measurements at a point or on a plane, the complete flow field supplied by CFD simulations enables us to have a deeper understanding of the dynamics of coherent structures that are responsible for free-surface fluctuations and aeration in hydraulic jumps. Therefore, in recent years, the computational fluid dynamics (CFD) method, through turbulence models, has become a useful tool to study this complex environmental fluid mechanic problem.