Simulation of DVB-T2 integrated receiver decoder specifications for ASEAN countries

Abdullah, Jiwa; Abobaker, Ali Abduallah W.; Elijah, Olakunle

doi:10.1109/iccsce.2015.7482224

Cited by 2 publications

(1 citation statement)

References 5 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In addition, the statement from Xian Lin Huang and Jun Wu, Fei Hu, simulation results show KMV-Cast or typical linear video transmission called soft cast can reach a PSNR gain as Low SNR: 8db more, High SNR : 5db more and Traditional one : 7db more. They also focus on data compression than evaluate performance of the system under incomplete prior knowledge [7]. This means that the performance of DVB-T and DVB-T2 can be determined by test parameter and the quality of the audiovisual.…”

Section: Introductionmentioning

confidence: 99%

Measurement of digital video broadcasting-second generation terestrial (DVB-T2) signal in Kuala Lumpur, Malaysia

Ya’acob

Tajudin

Yusof

et al. 2019

IJEECS

View full text Add to dashboard Cite

DVB-T2 (Digital Video Broadcasting – Second Generation Terrestrial) is one of the latest technical standards being developed by the DVB Project for DTT (Digital Terrestrial Television). It is also known as digital broadcasting trough terrestrial system since 2006 and is an extension of the DVB-T system as a second generation program to improve efficiency of the total system. It is important to perform a research on the performance of DVB-T2 because Malaysia has launched the free-to-air digital TV project since 2016 hence there is a need to know how well the signal is being received by viewers. This research focuses on a DVB-T2 transmission process which involve the transmission from Menara Kuala Lumpur transmitter to receivers located at 100 different locations. The performance of DVB-T2 can be determined by measuring the field strength, MER (Module Error Ratio) and BERaLDPC (Bit Error Rate after Low Density Parity Check decoder), and then a comparison between DVB-T and DVB-T2 systems can be made. Equipments involved in the measurement are indoor antenna, distribution amplifier, waveform monitor, field strength meter, DVB-T2 decoder and TV set as the receiver. Results are recorded in Microsoft Excel and analyzed using MATLAB software. The result of the measurement shows92% of the test points had higher reading than the baseline value which means better reception of digital TV signal is delivered to the location.Comparison between DVB-T and DVB-T2 performance shows that field strength of the DVB-T2 system is slightly higher by 1.5 % – 3.8 % from DVB-TMeasurement of digital video broadcasting-second generation terestrial (DVB-T2) signal in Kuala Lumpur, Malaysia

show abstract

Section: Introductionmentioning

confidence: 99%

Measurement of digital video broadcasting-second generation terestrial (DVB-T2) signal in Kuala Lumpur, Malaysia

Ya’acob

Tajudin

Yusof

et al. 2019

IJEECS

View full text Add to dashboard Cite

show abstract

Digital Terrestrial Broadcast Standards

Montalbán

Iradier

Fanari

et al. 2021

Wiley Encyclopedia of Electrical and Electronics Engineering

View full text Add to dashboard Cite

The European Digital Video Broadcasting (DVB) project started in 1993 as an industry forum providing the specifications for digital broadcast. Afterwards, the first Digital Terrestrial Television (DTT) system, DVB‐Terrestrial (DVB‐T), was standardized in 1997, and one year later, the first DVB‐T broadcast began in Sweden and the UK. In September 2009, ETSI published the first version of the second generation standard (DVB‐T2), where the data‐carrying capacity of a single Radio Frequency (RF) broadcast channel was notably increased. Specifically, a minimum capacity increase of 30% was achieved as well as improved SFN performances, a mechanism to reduce the peak‐to‐average‐power ratio (PAPR), sand a flexible frame structure for Physical Layer Pipes (PLPs). This article starts with a system overview of the DVB‐T2 standard, and then, the general architecture of the DVB‐T2 transceiver is comprehensively described module by module. This work also gathers a comprehensive review of the available implementation and evaluation results of the standard.

show abstract

Simulation of DVB-T2 integrated receiver decoder specifications for ASEAN countries

Cited by 2 publications

References 5 publications

Measurement of digital video broadcasting-second generation terestrial (DVB-T2) signal in Kuala Lumpur, Malaysia

Measurement of digital video broadcasting-second generation terestrial (DVB-T2) signal in Kuala Lumpur, Malaysia

Digital Terrestrial Broadcast Standards

Contact Info

Product

Resources

About