Semi-numerical analysis of heat transfer performance of fractal based tube bundle in shell-and-tube heat exchanger

Zhou, Jianfeng; Wu, Shiwei; Chen, Yao; Shao, Changzheng

doi:10.1016/j.ijheatmasstransfer.2015.01.038

Cited by 9 publications

(1 citation statement)

References 27 publications

(44 reference statements)

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The most used and widespread type of heat exchangers found in these industries are the shelland-tube types. The high level of acceptance of shell-andtube heat exchanger (STHE) is due to its robustness and versatile materials used in construction, ease of maintenance and very wide range of operating conditions [4][5][6][7].…”

Section: Introductionmentioning

confidence: 99%

Numerical Investigation of the Concave-Cut Baffles Effect in Shell-and-Tube Heat Exchanger

Petinrin¹,

Dare²

2019

JES

View full text Add to dashboard Cite

In this paper, the performance of shell-and-tube heat exchangers with single-segmental baffle and varying configurations of concave-cut baffles (10, 15 and 20 %) was investigated. The study was carried out for a heat exchanger having either engine oil, water and air as shell-side fluid. For each configuration of the baffles, the results of both the the k-ε and RNG k-ε turbulent models were in very close agreement. The heat exchangers with concavecut baffles had higher pressure drops and lower performance factors than that of single-segmental baffle at the same range of mass flow rates for all fluid cases. Also, the concave-cut baffle heat exchangers had lower shell-side heat transfer coefficients at the same pressure drop against that of single-segmental baffles. Thus, the use of concave-cut baffles did not exhibit desirable performance in heat exchanger as compared with the segmental baffles.

show abstract

Section: Introductionmentioning

confidence: 99%