Abstract:SbstractThe rheological properties of acrylic paints and polyaniline (PAni) blends, with different contents of PAni doped by dodecyl benzene sulphonic acid (DBSA) and, dispersed by mechanical stirrer and ultrasonic, were investigated by controlled shear rate testing ramps. The results showed that the commercial acrylic paint had tended to deliver the required stability on the blends, in order to avoid sedimentation process. All samples exhibited non-Newtonian flow behavior (shear thinning), increasing PAni con… Show more
“…A consistent trend was observed in K and n value, depending on the factorial level. In the literature, similar tendency was observed in epoxy coating with nanoparticles [5,12,23,24].…”
Section: Also Indicates That Increasing Nanoparticles Concentration Cause a Considerable Non-linear Increase In Consistency Coefficients supporting
confidence: 79%
“…Complex fluids with weakly aggregated internal structures often present thixotropic behavior, defined as a flow-induced reversible time-dependent shear-thinning viscous response [12,20]. An important criterion of thixotropy is the reversible effect, when the substance is left to rest.…”
Section: Thixotropy Measurementsmentioning
confidence: 99%
“…In our previous studies, commercial acrylic paint with conductive carbon black were studied, to modify the original paint characteristic and obtain a clear comprehension of the filler influence on paint rheology [12].…”
The purpose of this paper was determining the effects of two nanoparticles additions in a commercial epoxy coating system on rheology characterization. Two kinds of hybrid organic–inorganic silicates (benzytallowdimethylammonium salts with bentonite) were studied, APA, with C14-16 organic chain and, HT, with C2-4 organic chain. A 22 factorial design, with two categorical nanoparticules factors was applied. The experimental data of viscosity were fit to three different rheological constitutive models: Herschell-Bulkley, Carreau-Yasuda and Cross. The best fit was obtained by Herschel-Bulkley model. The APA nanoparticle had substantial changes in yield stress values, but no effect was observed when HT had been isolated. Two thixotropic models were analyzed for the epoxy system, and the better performance was observed for the model with two rheological parameters. The presence of nanoparticule in epoxy coating reduced around 40% the recovery time. The addition of nanoparticules changes the rheological properties of a commercial coating. The X-Rays Diffraction analyses were done to observe the dispersions degree and exfoliations in the epoxy system. The crystalline peak of nanoparticles had lost for all coating formulations. The electromagnetic interference shielding attenuation was 60% in the formulations with high content of both nanoparticles. The APA and HT improved hence, the anticorrosion performance of the epoxy coating for 720 h in chloride solution. Corrosion resistance had the best performance in the coating with high concentration of carbon black and nanoparticles.
“…A consistent trend was observed in K and n value, depending on the factorial level. In the literature, similar tendency was observed in epoxy coating with nanoparticles [5,12,23,24].…”
Section: Also Indicates That Increasing Nanoparticles Concentration Cause a Considerable Non-linear Increase In Consistency Coefficients supporting
confidence: 79%
“…Complex fluids with weakly aggregated internal structures often present thixotropic behavior, defined as a flow-induced reversible time-dependent shear-thinning viscous response [12,20]. An important criterion of thixotropy is the reversible effect, when the substance is left to rest.…”
Section: Thixotropy Measurementsmentioning
confidence: 99%
“…In our previous studies, commercial acrylic paint with conductive carbon black were studied, to modify the original paint characteristic and obtain a clear comprehension of the filler influence on paint rheology [12].…”
The purpose of this paper was determining the effects of two nanoparticles additions in a commercial epoxy coating system on rheology characterization. Two kinds of hybrid organic–inorganic silicates (benzytallowdimethylammonium salts with bentonite) were studied, APA, with C14-16 organic chain and, HT, with C2-4 organic chain. A 22 factorial design, with two categorical nanoparticules factors was applied. The experimental data of viscosity were fit to three different rheological constitutive models: Herschell-Bulkley, Carreau-Yasuda and Cross. The best fit was obtained by Herschel-Bulkley model. The APA nanoparticle had substantial changes in yield stress values, but no effect was observed when HT had been isolated. Two thixotropic models were analyzed for the epoxy system, and the better performance was observed for the model with two rheological parameters. The presence of nanoparticule in epoxy coating reduced around 40% the recovery time. The addition of nanoparticules changes the rheological properties of a commercial coating. The X-Rays Diffraction analyses were done to observe the dispersions degree and exfoliations in the epoxy system. The crystalline peak of nanoparticles had lost for all coating formulations. The electromagnetic interference shielding attenuation was 60% in the formulations with high content of both nanoparticles. The APA and HT improved hence, the anticorrosion performance of the epoxy coating for 720 h in chloride solution. Corrosion resistance had the best performance in the coating with high concentration of carbon black and nanoparticles.
“…In contrast, at 15% PANI loading, complete shear thinning or pseudoplasticity is observed throughout the testing range. This non‐Newtonian behavior is ascribed to the textural changes in the sample with increase in shear rate . The shear thinning arising at low shear rate is due to the rise in stiffness of system by the formation of the PANI aggregates .…”
“…A reologia é ferramenta fundamental para o bom entendimento das propriedades e aplicações das tintas e revestimentos poliméricos ROGER;TANNER, 2010;SIRQUEIRA et al, 2016;WU;QUEIROZ;MOHALLEM, 2016). O fenômeno de tixotropia é comum em tintas,sendo uma característica reológica interessante (redução da viscosidade com o tempo de aplicação de uma taxa de cisalhamento).…”
CIP) (eDOC BRASIL, Belo Horizonte/MG) I34 Impactos das tecnologias na engenharia química [recurso eletrônico] / Organizadora Carmen Lúcia Voigt. -Ponta Grossa (PR): Atena Editora, 2019. -(Impactos das Tecnologias na Engenharia Química; v. 1) Formato: PDF 1. Engenharia química -Pesquisa -Brasil. I. Voigt, Carmen Lúcia. II. Série. CDD 660.76 Elaborado por Maurício Amormino Júnior -CRB6/2422 O conteúdo dos artigos e seus dados em sua forma, correção e confiabilidade são de responsabilidade exclusiva dos autores.2019 Permitido o download da obra e o compartilhamento desde que sejam atribuídos créditos aos autores, mas sem a possibilidade de alterá-la de nenhuma forma ou utilizá-la para fins comerciais.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.