Reduced graphene oxide as an adhesion enhancer of fusion-bonded epoxy coatings

Medeiros, Felipe da Silva; Cury, Camila S.R.; Vasconcelos, Cláudia Karina Barbosa de; Silva, Glaura G.

doi:10.1016/j.porgcoat.2022.107057

Cited by 5 publications

(2 citation statements)

References 76 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In this context, some authors have found the increase of hydrophilicity, thermal stability, and cell adhesion in scaffolds when graphene oxide (GO) is used in synergism with biodegradable polymers 21,24–26 . GO is a nanomaterial formed by carbon sheets in a hexagonal arrangement highly functionalized with oxygenated groups, and the oxygen functions are distributed along the basal plane attached to the edges, such as hydroxyl, epoxy, carbonyl and carboxyl groups 27 . It has been widely employed in research and industry because of its attractive properties such as large surface area, optical transmittance, excellent electrical conductivity, and thermal properties 28 .…”

Section: Introductionmentioning

confidence: 99%

“…21,[24][25][26] GO is a nanomaterial formed by carbon sheets in a hexagonal arrangement highly functionalized with oxygenated groups, and the oxygen functions are distributed along the basal plane attached to the edges, such as hydroxyl, epoxy, carbonyl and carboxyl groups. 27 It has been widely employed in research and industry because of its attractive properties such as large surface area, optical transmittance, excellent electrical conductivity, and thermal properties. 28 For example, Liu et al polymerized ultrathin GO on the surface of MIL-88A(Fe) and obtained an improved photocatalytic efficiency.…”

mentioning

confidence: 99%

See 1 more Smart Citation

Additive manufacturing of 3D networks based on poly(lactic acid) and amine functionalized graphene oxide as a platform for scaffolds

Pinto,

da Silva Medeiros,

Nunes

et al. 2024

J of Applied Polymer Sci

View full text Add to dashboard Cite

In the present study, 3D networks were printed using the fused deposition modeling (FDM) technique. The purpose was investigate the printability of graphene oxide (GO)‐based composites for potential bone tissue engineering applications. Poly(lactic acid) (PLA) filaments containing GO and amine functionalized GO (N‐GO) were produced by melt extrusion and employed to print 3D networks. The cytotoxicity, morphological, rheological, and thermal behavior of the samples were compared. The morphological, rheological, and wettability analyses indicated an improvement in dispersion of GO throughout the matrix of PLA when GO was amine functionalized. The viscoelastic and flow properties, as determined by rheology, indicated that printed PLA samples containing freeze‐dried GO had lower viscosity than other composites, with a viscosity of 59.4 (Pa s), a decrease of nine times when compared with pure PLA, while the PLA containing N‐GO presented an improved viscoelastic interaction. PLA contact angle (108°) decreased by 87° and 84° for N‐GO and GO, respectively. The thermal analyses depicted that the incorporation of freeze‐dried GO and N‐GO had no effect on the crystallinity or thermal transitions of PLA matrix, maintaining its thermal stability. Finally, the cytotoxicity analysis indicated that the composites were not toxic throughout the cell culture assay and were found to promote cell viability, especially for the PLA/N‐GO network. Thus, these results revealed a vast horizon toward the use of GO/biodegradable polymers as platforms to print 3D networks to be applied as scaffolds.

show abstract

Section: Introductionmentioning

confidence: 99%

mentioning

confidence: 99%