Pulsed jet combustion—Key to a refinement of the stratified charge concept

Maxson, J.A.; Oppenheim, A. K.

doi:10.1016/s0082-0784(06)80362-0

Cited by 29 publications

(7 citation statements)

References 10 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…By the use of a variety of ignition systems, the experiments covered a wide range of operating conditions, from an apparently laminar flame to a fully developed turbulent combustion. This was achieved by the use of three distinct modes of executing the exothermic process: (1) spark-ignited flame traversing the charge, F, (2) single stream flame jet (referred to previously as PJC (pulsed jet combustion) or PCJ (pulsed combustion jet) [27,28,29]) initiated combustion, S, and (3) triple-stream flame jet combustion, T. A detailed report on this study is outside the scope of this paper.…”

Section: Methodsmentioning

confidence: 99%

Energy loss from closed combustion systems

Oppenheim

Kuhl

2000

Proceedings of the Combustion Institute

Self Cite

View full text Add to dashboard Cite

Section: Methodsmentioning

confidence: 99%

Energy loss from closed combustion systems

Oppenheim

Kuhl

2000

Proceedings of the Combustion Institute

Self Cite

View full text Add to dashboard Cite

“…Later, Oppenheim et al [14][15][16] at the University of California, Berkeley developed a similar ignition concept termed Jet Plume Injection and Combustion (JPIC). The JPIC igniter is essentially a miniaturized version of the valve-operated LAG combustion system that can be installed into an engine similar to a direct injector [8,15].…”

Section: Introductionmentioning

confidence: 99%

A study of a turbulent jet ignition system fueled with iso-octane: Pressure trace analysis and combustion visualization

2017

View full text Add to dashboard Cite

Turbulent Jet Ignition is an advanced pre-chamber ignition enhancement technique for spark ignition engines that uses a discharging jet of hot combusting gases to initiate main chamber combustion. The jet acts as a distributed ignition source, leading to fast burn rates and increased combustion stability. Experiments were performed in an optically accessible rapid compression machine using liquid iso-octane to study the effects of auxiliary fuel injection and ignition distribution due to nozzle geometry. A custom low-flow fuel injector was used to overcome previous limitations of using liquid fuel in the pre-chamber. Jet induced autoignition behavior was also studied in depth by considering high-speed images, pressure traces, and pressure derivative data.

show abstract

“…1,[4][5][6] The divided chamber-stratified charge ignition concept has been further developed over the years. [7][8][9][10][11][12] The jet plume injection and combustion (JPIC) igniter was later developed by Maxson and colleagues [10][11][12] at the University of California, Berkeley, and further investigated by Murase and colleagues. [13][14][15][16] In the 1990s, Watson and colleagues [17][18][19] introduced the prechamber (PC) ignition concept named hydrogenassisted jet ignition (HAJI).…”

Section: Introductionmentioning

confidence: 99%

“…The jet ignition concept was initially introduced in the late 1950s 4,5 under the name of LAG (Lavinaia Aktivatsia Gorenia) that was translated to “avalanche activated combustion.” 1,4–6 The divided chamber–stratified charge ignition concept has been further developed over the years. 7–12 The jet plume injection and combustion (JPIC) igniter was later developed by Maxson and colleagues 10–12 at the University of California, Berkeley, and further investigated by Murase and colleagues. 13–16…”

Section: Introductionmentioning

confidence: 99%

Large eddy simulation of a homogeneously charged turbulent jet ignition system

Gholamisheeri

Givler

Toulson

2017

International Journal of Engine Research

View full text Add to dashboard Cite

Transient jet ignition of a homogeneous methane air mixture in a turbulent jet ignition system is studied computationally using a large eddy simulation turbulence model. The jet discharges from a prechamber into a main combustion chamber via one or more orifice(s) and provides a distributed ignition source in turbulent jet ignition. The effect of orifice size and stoichiometry is studied numerically using the Converge computational fluid dynamics code. A reduced kinetic mechanism is used for combustion along with a Smagorinsky sub-model for turbulence modeling. The computed pressure traces are compared with experimental measurements through rapid compression machine tests. Computational fluid dynamics results are in acceptable agreement with the experimental data during compression and the early stage of combustion; however, an over-prediction of peak pressure was reported. Peak pressure error is in the range of 0.1%-4% for Reynolds-averaged Navier-Stokes simulation estimation compared to the experimental measurements. This error is a function of mixture stoichiometry and unburned gas temperature. The error calculation showed that with the large eddy simulation model, 1% and 12% improvements in peak pressure and burn rate estimations, respectively, were achieved compared to Reynolds-averaged Navier-Stokes results. The reduced large eddy simulation error relative to the Reynolds-averaged Navier-Stokes simulations were considered to be in the acceptable range; however, further improvements could be achieved through validation and testing of additional turbulence models. In addition, computational fluid dynamics temperature contours for various nozzle orifices and air-fuel ratios are compared to achieve deeper insight into the turbulent jet ignition combustion process in the rapid compression machine combustion cylinder. The numerical iso-surface temperature contours were obtained which enabled three-dimensional views of the flame propagation, the jet discharge, ignition and extinction events. The heat release process and regeneration of mid-range temperature iso-surfaces (1200 K) were not visible through the experimental images.

show abstract

Pulsed jet combustion—Key to a refinement of the stratified charge concept

Cited by 29 publications

References 10 publications

Energy loss from closed combustion systems

Energy loss from closed combustion systems

A study of a turbulent jet ignition system fueled with iso-octane: Pressure trace analysis and combustion visualization

Large eddy simulation of a homogeneously charged turbulent jet ignition system

Contact Info

Product

Resources

About