Processing, structure, and properties of fibers from polyester/carbon nanofiber composites

Ma, Hongming; Zeng, Jijun; Realff, Mary Lynn; Kumar, Satish; Schiraldi, David A.

doi:10.1016/s0266-3538(03)00071-x

Cited by 202 publications

(71 citation statements)

References 36 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Similar tendency is also observed in the tensile strength as presented in Table 1. The reinforcement efficiency of carbon nanotubes depends on the effect of the intrinsic mechanical properties as well as on the uniform distribution of MWCNTs and matrix-nanofiller interfacial adhesion [27]. The enhancement effect can be recognized in the nanocomposite systems after addition of either p-MWCNTs or f-MWCNTs in terms of the elongation at break.…”

Section: Mechanical Propertiesmentioning

confidence: 99%

Creep of thermoplastic polyurethane reinforced with ozone functionalized carbon nanotubes

Jia¹,

Jiang²,

Gong³

et al. 2012

Express Polym. Lett.

View full text Add to dashboard Cite

Abstract. This work focused on the mechanical behavior, especially creep resistance, of thermoplastic polyurethane (TPU) filled with ozone-treated multi-walled carbon nanotubes (MWCNTs). It was found that the ozone functionalization of MWCNTs could improve their dispersion and interfacial adhesion to the TPU matrix as proved by scanning electron microscope and Raman spectrometer. It finally contributed to the enhancement of Young's modulus and yield strength of TPU/MWCNT composites. Moreover, the creep resistance and recovery of MWCNT/TPU composites revealed a significant improvement by incorporating ozone functionalized MWCNTs. The strong interaction between the modified MWCNTs and TPU matrix would enhance the interfacial bonding and facilitate the load transfer, resulting in low creep strain and unrecovered strain.

show abstract

Section: Mechanical Propertiesmentioning

confidence: 99%

Creep of thermoplastic polyurethane reinforced with ozone functionalized carbon nanotubes

Jia¹,

Jiang²,

Gong³

et al. 2012

Express Polym. Lett.

View full text Add to dashboard Cite

show abstract

“…The degummed silk fibroin nano fibre nonwovens were applied for wound dressing and found to be favorable for cell attachment, growth and proliferation. Also the biomedical applications such as wound dressing and scaffolds for tissue engineering, 103,104 of nano fibres have been studied. Xie & Hsieh 105 prepared enzyme loaded fibres by the electro spinning of a solution containing enzyme and PEO/PVA and found that the reactivity of the enzyme was 6 times higher.…”

Section: Biomedical Applicationsmentioning

confidence: 99%

Nano Fibres by Electro spinning: Properties and Applications

Nayak¹,

Padhye²

2017

JTEFT

View full text Add to dashboard Cite

Electro spinning is a simple and versatile technique applicable to a wide range of polymers and solvents for the production of materials in nanometer scale. The nano fibrous materials produced by electro spinning process exhibit novel and significantly improved physical, chemical and biological properties. The small fibre diameter and the porous structure of the electrospun surfaces enable them for a wide range of applications such as wound dressing, tissue engineering scaffolds, vascular grafts, filters, membranes and sensors. In this article the principle, setup, materials used and the factors affecting the electro spinning process have been described. Also the properties & applications of electrospun fibres and the limitations & future scope of electro spinning process have been highlighted.

show abstract

“…Some rebundling of the aggregates is possible even after discontinuation of the external force [Yoonessi et al, 2008]. However, optimal loading and uniform dispersion of CNFs in matrix are the key parameters to promote better nanofibermatrix interface properties to reach an efficient load transfer between two constituents of the nanocomposite [Kozey et al, 1995;Ma et al, 2003]. …”

Section: Wwwintechopencommentioning

confidence: 99%

Scanning Electron Microscopy Study of Fiber Reinforced Polymeric Nanocomposites

Hossain¹

2012

Scanning Electron Microscopy

View full text Add to dashboard Cite

Processing, structure, and properties of fibers from polyester/carbon nanofiber composites

Cited by 202 publications

References 36 publications

Creep of thermoplastic polyurethane reinforced with ozone functionalized carbon nanotubes

Creep of thermoplastic polyurethane reinforced with ozone functionalized carbon nanotubes

Nano Fibres by Electro spinning: Properties and Applications

Scanning Electron Microscopy Study of Fiber Reinforced Polymeric Nanocomposites

Contact Info

Product

Resources

About