In this technical note we develop an adaptive tuned vibration absorber (ATVA) based on the unique characteristics of magnetorheological elastomers (MREs), whose modulus can be controlled by an applied magnetic field. The MRE used in the developed ATVA was prepared by curing a mixture of 704 silicon rubber, carbonyl iron particles and a small amount of silicone oil under a magnetic field. The ATVA works in shear mode and consists of an oscillator, smart spring elements with MREs, a magnet conductor and two coils. Natural frequencies of the ATVA under different magnetic fields were both theoretically analyzed and experimentally evaluated by employing a beam structure with two ends supported. The experimental results demonstrated that the natural frequency of the ATVA can be tuned from 55 to 82 Hz. The relative frequency change is as high as 147%. Furthermore, the absorption capacity of the developed ATVA can achieve as high as 60 dB, which was also experimentally justified.

No abstract

No abstract

The microstructures and viscoelastic properties of anisotropic magnetorheological elastomers are investigated. The measurement results show that their mechanical properties are greatly dependent on the magnetic flux density applied during preparation. A finite-column model is proposed to describe the relationships between the microstructures and the viscoelastic properties. The simulation results agree well with the experimental results.

A novel high-performance magnetorheological material, named as magnetorheological plastomer (MRP), was developed by dispersing iron particles into a plastic polyurethane (PU) matrix. The dynamic properties (including storage modulus and loss factor) of the MRP material were systematically tested and the influences of the iron particle content and magnetic field were analyzed. It is found that the anisotropic MRP product with 80% iron particle weight fraction (A-MRP-80), shows a high dynamic property: the maximum magneto-induced storage modulus is 6.54 MPa; the relative MR effect reaches as high as 532%; the loss factor can be reduced to 0.03 by adjusting magnetic field. This kind of MRP shows a much higher magnetorheological performance than the previously reported magnetorhelogical elastomer (MRE). The mechanism for its high MR performance was proposed and the influence of the iron particle distribution and temperature on the dynamic properties were discussed.

No abstract

No abstract

A tunable stiffness and damping vibration isolator based on magnetorheological elastomers (MREs) is developed. In this isolator, four MRE elements are used as the tunable springs, whose stiffness can be controlled by varying the magnetic field. A voice coil motor, which is controlled by the relative velocity feedback of the payload, is used as the tunable damper of the isolator. Under the combined ON–OFF control, the proposed vibration isolator shows satisfying isolation effect. The experimental results indicate that the responses of the payload are suppressed significantly in comparison to the passive system. The transmissibility of the payload around the resonant frequency is decreased by 61.5%. The root mean square (RMS) value and the maximum value of the displacement responses of the payload are decreased by 36.0% and 50.0%, respectively. In addition, the RMS values and maximum values of the velocity responses are decreased by 45.4% and 52.5%, respectively.