Problems of the anisotropy of strength

Ashkenazi, E. K.

doi:10.1007/bf00860686

Cited by 13 publications

(2 citation statements)

References 2 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…There are several suggestions in the literature (Ashkenazi, 1965;Goldenblat and Kopnov, 1965;Hashin, 1980;Mālmeisters et al, 1977;Schürmann, 2007;Christensen, 2013;Ganczarski and Skrzypek, 2013). The aim of the modification is to take into account the anisotropy of the material behavior.…”

Section: Anisotropic Failure Criteriamentioning

confidence: 99%

Failure and Damage Analysis of Advanced Materials

Altenbach¹,

Sadowski²

2015

CISM International Centre for Mechanical Sciences

View full text Add to dashboard Cite

translation, reprinting, reuse of illustrations, recitation, broadcasting, reproduction on micro lms or in any other physical way, and transmission or information storage and retrieval, electronic adaptation, computer software, or by similar or dissimilar methodology now known or hereafter developed. Exempted from this legal reservation are brief excerpts in connection with reviews or scholarly analysis or material supplied speci cally for the purpose of being entered and executed on a computer system, for exclusive use by the purchaser of the work.

show abstract

Section: Anisotropic Failure Criteriamentioning

confidence: 99%

Failure and Damage Analysis of Advanced Materials

Altenbach¹,

Sadowski²

2015

CISM International Centre for Mechanical Sciences

View full text Add to dashboard Cite

show abstract

“…Similarly, the wood's grain has a strong effect on strength. The failure mode is different though--the crack always follows the grain and is not perpendicular to it [15][16][17]. Fabiane Salles proposed a new way to demand the elasticity modulus under a compression load.…”

Section: Static Mechanical Propertymentioning

confidence: 99%

Advances in the study of mechanical properties and constitutive law in the field of wood research

Zhao¹,

Zhao²,

Han³

2016

IOP Conf. Ser.: Mater. Sci. Eng.

View full text Add to dashboard Cite

Abstract. This paper presents an overview of mechanical properties and constitutive law for wood. Current research on the mechanical properties of wood have mostly focused on density, grain, moisture, and other natural factors. It has been established that high density, dense grain, and high moisture lead to higher strength. In most literature, wood has been regarded as an anisotropic material because of its fiber. A microscopic view is used in research of wood today, in this way, which has allowed for clear observation of anisotropy. In general, wood has higher strength under a dynamic load, and no densification. The constitutive model is the basis of numerical analysis. An anisotropic model of porous and composite materials has been used for wood, but results were poor, and new constitutions have been introduced. According to the literature, there is no single theory that is widely accepted for the dynamic load. Research has shown that grain and moisture are key factors in wood strength, but there has not been enough study on dynamic loads so far. Hill law has been the most common method of simulation. Models that consider high strain rate are attracting more and more attention.

show abstract

Experimental Mechanics Applied to the Accelerated Characterization of Polymer Based Composite Materials

Brinson

1981

New Physical Trends in Experimental Mechanics

View full text Add to dashboard Cite

Problems of the anisotropy of strength

Cited by 13 publications

References 2 publications

Failure and Damage Analysis of Advanced Materials

Failure and Damage Analysis of Advanced Materials

Advances in the study of mechanical properties and constitutive law in the field of wood research

Experimental Mechanics Applied to the Accelerated Characterization of Polymer Based Composite Materials

Contact Info

Product

Resources

About