Pre-design strategies and sizing techniques for dual-energy aircraft

Abstract

Purpose -The aim of this study was to first establish foundational algebraic expressions that parametrically describe any advanced dual-energy storagepropulsion-power system (DESPPS) and then proceed to declare the array of fundamental independent variables necessary for the sizing and optimisation of such systems. Upon procurement of a pre-design-level integrated aircraft performance model and the subsequent verification against previously published high-end low-fidelity generated results, opportunity was taken in formulating a set of battery-based DESPPS related design axioms and sizing heuristics. Design/methodology/approach -Derivation of algebraic expressions related to describing DESPPS architectures are based on first principles. Integrated performance modelling by way of full analytical fractional change transformations anchored according to a previously published Energy Specific Air Range (ESAR) figure-of-merit originally derived using the Breguet-Coffin differential equation for vehicular efficiency. Weights prediction of sub-systems that constitute the entire aircraft including DESPPS constituents emphasises an analytical foundation with minimal implementation of linear correlation factors or coefficients of proportionality. An iterative maximum take-off weight build-up algorithm emphasising expedient and stable convergence was fashioned. All prediction methods pertaining to integrated performance were verified according to previously published battery-based DESPPS results utilising high-end low-fidelity methods. Findings -For all types of DESPPS, two new fundamental independent non-dimensional variables were declared: the Supplied Power Ratio (related to converted power afforded by each energy carrier); and, the Activation Ratio (describing the relative nature of utilisation with respect to time afforded by the motive power device associated with each energy source). For a given set of standalone sub-system energy conversion efficiencies, the parametric descriptor of degree-of-hybridisation (DoH) for Power was found to be solely a function of the Supplied Power Ratio, whereas in contrast, the DoH for Energy was found to be a more complex synthetic function described by comingling of Supplied Power Ratio and the Activation Ratio. Upon examination of the integrated aircraft performance model derived in this treatise, for purposes of investigating CO 2 -emissions reduction potential for battery-based DESPPS using kerosene as one of the energy sources, one salient observation was maximising the ESAR figure-of-merit is not an appropriate objective or intermediary function for future optimisation work. It was found maximising block fuel reduction through the use of maximum ESAR would lead to ever diminishing design ranges and curtailment of the payload-range working capacity of the aircraft. Practical implications -Opportunity is now given to design and optimise aircraft utilising any type of DESPPS architecture. It was established that designing for battery-based DESPPS aircraft can be achieved effectively...

Analysis and design of hybrid electric regional turboprop aircraft

“…An introduction to turboprop generalized performance can be found in [35]. An alternative design and sizing approach for hybrid electric aircraft is reported in [36]. As a first step after implementation of the new sizing modules, the design and analysis method is applied to the design of a reference aircraft which has the same top-level aircraft requirements as the ATR-72-600.…”

Conceptual Design of Operation Strategies for Hybrid Electric Aircraft

“…Deeper insights about the role of the embedded battery performance in the overall aircraft design (OAD) are not provided. Isikveren et al [9] make first research efforts about hybrid electric propulsion strategies. Nevertheless, only the cruise mission segment is regarded and battery specific parameters such as power-to-energy ratios are not considered.…”

Electric Drives for Propulsion System of Transport Aircraft

“…With regards to morphology, besides the BWB configuration, no large departure from the traditional "tube and wing" were foreseen due to the implementation of hybrid-electric propulsion system. Outcome of pre-design studies investigated by Isikveren et al [63] indicated that unless significant departure in the propulsion system integration is entertained, considering for instance distributed propulsion technology, the contemporary tube-and-wing morphology was still considered to be appropriate. Distributed propulsion technology could considerably disrupt contemporary aircraft design paradigm.…”

“…The parameter He block refers, for instance, to the block mission. The need for the dual set of parametric descriptors is elucidated by Isikveren et al [63] considering the following examples:…”

“…The algebraic description of a hybrid-electric propulsion requires the establishment of two parametric descriptors [63,64]: the Degree of Hybridization for Power (Hp) and the Degree of Hybridization for Energy (He). The parameter Hp describes the amount of electrical power relative to the overall total power.…”