Polyethersulfone foils as stable transparent substrates for conductive copper sulfide thin film coatings

Nair, P. K.; Cardoso, J.; Daza, Oscar Gomez; Nair, M. T. S.

doi:10.1016/s0040-6090(01)01629-7

Cited by 28 publications

(11 citation statements)

References 24 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In the bulk form Cu x S exists in five stable phases where 'x' falls in the range between 1 and 2. Nair et al [134] deposited CuS thin films on polyethersulfone foil. Amorphous Cu x S films in the phase of chalcocite (x ¼ 2) deposited on Si and glass substrates by Nien et al [135] showed a homogeneous distribution of copper and sulphur based on the electron energy loss spectrometer (EELS) elemental mapping images.…”

Section: Copper Sulphide (Cu X S)mentioning

confidence: 99%

Recent status of chemical bath deposited metal chalcogenide and metal oxide thin films

Pawar

Kim

et al. 2011

Current Applied Physics

327

124

View full text Add to dashboard Cite

Section: Copper Sulphide (Cu X S)mentioning

confidence: 99%

Recent status of chemical bath deposited metal chalcogenide and metal oxide thin films

Pawar

Kim

et al. 2011

Current Applied Physics

327

124

View full text Add to dashboard Cite

“…A total of 3 SEM micrographs from 3 different samples of composite films were observed. The sheet resistance of deposited films was measured based on the method reported by Nair et al [16]. The surface resistance (sheet resistance) of deposited films was measured across a pair of silver electrodes of 10 mm in length and separated at 10 mm from each other as painted on the surface of the films.…”

Section: Deposition Of Mno 2 Thin Film On Ni/cus/pet Substratementioning

confidence: 99%

“…Deposition of copper sulfide thin films onto nonconductive polymeric materials has come into the limelight due to its wide range of applications in photothermal conversion, photovoltaic devices, selective solar-radiation filters, and electroconductive coatings for the deposition of metals [13,14]. The depositions of CuS thin films on various polymeric surfaces reported include polyimide [15], polyethersulfone [16], polyethylene terephthalate (PET) [17], and ABS [18]. The deposition of CuS thin films onto PET substrate by the chemical bath deposition method is particularly advantageous due to its low temperature requirement, relatively simple setup, and low cost [17].…”

Section: Introductionmentioning

confidence: 99%

Nanostructured Multilayer Composite Films of Manganese Dioxide/Nickel/Copper Sulfide Deposited on Polyethylene Terephthalate Supporting Substrate

Metosen

Pang

Chin

2015

Journal of Nanomaterials

View full text Add to dashboard Cite

Nanostructured multilayer manganese dioxide/nickel/copper sulfide (MnO2/Ni/CuS) composite films were successfully deposited onto supporting polyethylene terephthalate (PET) substrate through the sequential deposition of CuS, Ni, and MnO2thin films by chemical bath deposition, electrodeposition, and horizontal submersion deposition techniques, respectively. Deposition of each thin-film layer was optimized by varying deposition parameters and conditions associated with specific deposition technique. Both CuS and Ni thin films were optimized for their electrical conductivity whereas MnO2thin film was optimized for its microstructure and charge capacity. The electrochemical properties of nanostructured multilayer MnO2/Ni/CuS composite films were evaluated by cyclic voltammetry as electrode materials of an electrochemical capacitor prototype in a dual-planar device configuration. Cyclic voltammogram in mild Na2SO4aqueous electrolyte exhibited a featureless and almost rectangular shape which was indicative of the ideal capacitive behavior and high cycling reversibility of the electrochemical capacitor prototype. Nanostructured multilayer MnO2/Ni/CuS composite films on supporting polyethylene terephthalate (PET) substrate could potentially be utilized as electrode materials for the fabrication of high performance electrochemical capacitors.

show abstract

“…Copper sulphides (Cu x S) are widely applied in many applications due to their semiconductive nature [14][15][16][17][18][19][20][21]. They are composed of Cu 2 S and CuS and x depends on their molar ratio.…”

Section: Introductionmentioning

confidence: 99%

Exposure Studies of Different Kinds of Volatile Organic Compounds in Vapour Phase with a Narrow-gap Cell Containing CuxS Modified Carbon Microdisc Electrode

Kiss¹

2018

Period. Polytech. Chem. Eng.

View full text Add to dashboard Cite

In this article, the feasibility of the CuxS modified carbon microdisc electrode was examined by exposure to four different volatile organic compounds (2-propanol, acetic acid, ethyl acetate and n-butylamine) directly in their vapour phase using cyclic voltammetry and amperometry. The performance of the modified microdisc was compared with the bare carbon microdisc (30 μm in diameter) which was involved in a narrow-gap cell. By using both methods high current increase was observed for 2-propanol with the modified electrode and its sensitivity was sufficiently higher than with the bare electrode. The modified electrode showed lower current signals in case of acetic acid and n-butylamine. The latter formed a condensation layer at the interelectrode gap. Neither the bare nor the modified electrode was sensitive to ethyl acetate.

show abstract

Polyethersulfone foils as stable transparent substrates for conductive copper sulfide thin film coatings

Cited by 28 publications

References 24 publications

Recent status of chemical bath deposited metal chalcogenide and metal oxide thin films

Recent status of chemical bath deposited metal chalcogenide and metal oxide thin films

Nanostructured Multilayer Composite Films of Manganese Dioxide/Nickel/Copper Sulfide Deposited on Polyethylene Terephthalate Supporting Substrate

Exposure Studies of Different Kinds of Volatile Organic Compounds in Vapour Phase with a Narrow-gap Cell Containing CuxS Modified Carbon Microdisc Electrode

Contact Info

Product

Resources

About