Performance of a 250 kW Organic Rankine Cycle System for Off-Design Heat Source Conditions

Abstract

An organic Rankine cycle system comprised of a preheater, evaporator, condenser, turbine, generator, and pump was used to study its off-design performance and the operational control strategy. R245fa was used as the working fluid. Under the design conditions, the net power output is 243 kW and the system thermal efficiency is 9.5%. For an off-design heat source flow rate (m W ), the operating pressure was controlled to meet the condition that the R245fa reached the liquid and vapor saturation states at the outlet of the preheater and the evaporator, respectively. The analytical results demonstrated that the operating pressure increased with increasing m W ; a higher m W yielded better heat transfer performance of the preheater and required a smaller evaporator heat capacity, and the net power output and system thermal efficiency increased with increasing m W . For the range of m W studied here, the net power output increased by 64.0% while the total heat transfer rate increased by only 9.2%. In summary, off-design operation of the system was examined for a heat source flow rate which varied by -39.0% to +78.0% from the designed rate, resulting in -29.2% to +16.0% and -25.3% to +12.6% variations in the net power output and system thermal efficiency, respectively. OPEN ACCESSEnergies 2014, 7 3685

Thermodynamic Analysis and Sizing of a Small Scale Solar Thermal Power System Based on Organic Rankine Cycle

“…The working fluid properties were evaluated using the built-in thermo-physical properties database of Thermolib. To validate the developed Thermolib simulation model, comparisons between the present model results and those obtained from Fu et al [32] were performed by setting the same operating conditions and using the same working fluid, i.e., R245fa. The mass flow rate of R245fa was kept at a fixed value of 11.85 kg/s.…”

“…The comparisons were carried out for a range of the heat source mass flow rates of 10.0-25.0 kg/s. The present model results and those obtained from [32] for the variations of the system efficiency with the heat source mass flow rate are shown in Table 4. It can be seen that the predicted results from the present model and those published in [32] are in very good agreement.…”

Energy efficiency enhancement of a thermal power plant by novel heat integration of Internal Combustion Engine, Boiler, and Organic Rankine Cycle

“…However, for smaller systems (<10 kW) and scroll type (<100 kW), screw-type expanders are used and results are available in the literature for these smaller size ORCs, but these systems cannot be compared with the present study. 19,35 F I G U R E 1 4 The power output of an ORC system in three distinct scenarios plotted against the refrigerant pressure.…”

“…The techno‐economic feasibility analysis of an ORC power system for waste heat recovery is also performed. Furthermore, a comparative analysis is performed with a previous study on a 250‐kW ORC system 19 …”

Thermodynamic Optimization of a Geothermal- Based Organic Rankine Cycle System Using an Artificial Bee Colony Algorithm

“…The majority of application areas experience variations in thermal resource (or cooling processes) over time and the system should adapt to the working regime to ensure optimum performance. There are few studies related to control aspects and off-design performance of ORC systems [23][24][25][26][27][28][29][30][31][32][33][34][35]. Thus, all the following studies are related to low temperature ORCs.…”