Optimized Common-Mode Voltage Reduction PWM for Three-Phase Voltage-Source Inverters

Wu, Xiang; Tan, Guojun; Ye, Zongbin; Liu, Yi; Xu, Shukai

doi:10.1109/tpel.2015.2451673

Cited by 72 publications

(36 citation statements)

References 30 publications

Supporting

Mentioning

Contrasting

Unclassified

Order By: Relevance

“…All signals are converted by a digital-to-analog chip (TLV5610) and displayed on a digital oscilloscope. The traditional two-level inverter topology is adopted [30]. Switching frequency of the inverter and sampling frequency of the control system are set to 10 kHz.…”

Section: Resultsmentioning

confidence: 99%

Sensorless Control for IPMSM Based on Adaptive Super-Twisting Sliding-Mode Observer and Improved Phase-Locked Loop

Chen

Zhang

et al. 2019

Energies

Self Cite

View full text Add to dashboard Cite

In traditional sensorless control of the interior permanent magnet synchronous motors(IPMSMs) for medium and high speed domains, a control strategy based on a sliding-mode observer(SMO) and phase-locked loop (PLL) is widely applied. A new strategy for IPMSM sensorless controlbased on an adaptive super-twisting sliding-mode observer and improved phase-locked loop isproposed in this paper. A super-twisting sliding-mode observer (STO) can eliminate the chatteringproblem without low-pass filters (LPFs), which is an effective method to obtain the estimated backelectromotive forces (EMFs). However, the constant sliding-mode gains in STO may causeinstability in the high speed domain and chattering in the low speed domain. The speed-relatedadaptive gains are proposed to achieve the accurate estimation of the observer in wide speed rangeand the corresponding stability is proved. When the speed of IPMSM is reversed, the traditionalPLL will lose its accuracy, resulting in a position estimation error of 180°. The improved PLL basedon a simple strategy for signal reconstruction of back EMF is proposed to ensure that the motor canrealize the direction switching of speed stably. The proposed strategy is verified by experimentaltesting with a 60-kW IPMSM sensorless drive.

show abstract

Section: Resultsmentioning

confidence: 99%

Sensorless Control for IPMSM Based on Adaptive Super-Twisting Sliding-Mode Observer and Improved Phase-Locked Loop

Chen

Zhang

et al. 2019

Energies

Self Cite

View full text Add to dashboard Cite

show abstract

“…Experiments on a 2-level IPMSM drive system [32] were subsequently carried out to further verify the effectiveness of the proposed observer. The composition of the IPMSM test platform is given in Figure 8, where a DSP TMS320F2812 was chosen as the MCU and output signals of a D/A chip (TLV5610) were displayed by an oscilloscope to monitor system variables in real-time.…”

Section: Resultsmentioning

confidence: 99%

A Super-Twisting Sliding-Mode Stator Flux Observer for Sensorless Direct Torque and Flux Control of IPMSM

Chen

et al. 2019

Energies

Self Cite

View full text Add to dashboard Cite

The scheme based on direct torque and flux control (DTFC) as well as active flux is a good choice for the interior permanent magnet synchronous motor (IPMSM) sensorless control. The precision of the stator flux observation is essential for this scheme. However, the performance of traditional observers like pure integrator and the low-pass filter (LPF) is severely deteriorated by disturbances, especially dc offset. Recently, a sliding-mode stator flux observer (SMFO) was proposed to reduce the dc offset in the estimated stator flux. However, it cannot eliminate the dc offset totally and will cause the chattering problem. To solve these problems, a novel super-twisting sliding-mode stator flux observer (STSMFO) is proposed in this paper. Compared with SMFO, STSMFO can reduce the chattering and fully eliminate the dc offset without any amplitude and phase compensation. Then, the precision of the stator flux and rotor position can be greatly improved over a wide speed region. The detailed mathematical analysis has been given for comparing it with another three traditional observers. The numerical simulations and experimental testing with an IPMSM drive platform have been implemented to verify the capability of the proposed sensorless scheme.

show abstract

“…Because the non-nearest vectors for two triangles were selected in the PWM, this causes the total harmonic distortion (THD) of the line-to-line voltage to be higher than the conventional method. Similar PWMs have been presented in References [11][12][13][14]. However, these PWMs are difficult to extend to higher levels.…”

Section: Introductionmentioning

confidence: 85%

A SVPWM to Eliminate Common-Mode Voltage for Multilevel Inverters

et al. 2017

View full text Add to dashboard Cite

This paper presents a new space vector pulse width modulation (SVPWM) to eliminate common-mode voltage (CMV) for multilevel inverters. The proposed SVPWM is performed in a new coordinate system, in which the converter voltage vectors have only integer entries and the absolute coordinate increment between adjacent vectors is equal to 1. The location of the reference vector, detection of the nearest three CMV vectors, and duty cycles of the nearest three CMV vectors are all obtained by simple calculations, no lookup table is needed and the SVPWM is computationally fast. Compared with earlier pulse width modulations (PWMs), the realization of the CMV vectors is very simple, and the CMV of multilevel inverters are limited to zero with any modulation index. Because the SVPWM is independent of the level number of the inverter, the proposed SVPWM is suitable for any level of inverter. This paper also thoroughly compares the proposed SVPWM with prior PWMs. Experimental results are also given in the paper.

show abstract

Optimized Common-Mode Voltage Reduction PWM for Three-Phase Voltage-Source Inverters

Cited by 72 publications

References 30 publications

Sensorless Control for IPMSM Based on Adaptive Super-Twisting Sliding-Mode Observer and Improved Phase-Locked Loop

Sensorless Control for IPMSM Based on Adaptive Super-Twisting Sliding-Mode Observer and Improved Phase-Locked Loop

A Super-Twisting Sliding-Mode Stator Flux Observer for Sensorless Direct Torque and Flux Control of IPMSM

A SVPWM to Eliminate Common-Mode Voltage for Multilevel Inverters

Contact Info

Product

Resources

About