Optimization Study of the Capacity of Chlorella vulgaris as a Potential Bio-Remediator for the Bio-Adsorption of Arsenic (III) from Aquatic Environments

Abstract

This study examined the ability of the green microalgae Chlorella vulgaris to remove arsenic from aqueous solutions. A series of studies was conducted to determine the optimal conditions for biological arsenic elimination, including biomass amount, incubation time, initial arsenic level, and pH values. At 76 min, pH 6, 50 mgL−1 metal concentration, and 1 gL−1 bio-adsorbent dosage, the maximum removal of arsenic from an aqueous solution was 93%. The uptake of As (III) ions by C. vulgaris reached an equilibrium at 76 min of bio-adsorption. The maximum adsorptive rate of arsenic (III) by C. vulgaris was 55 mg/gm. The Langmuir, Freundlich, and Dubinin–Radushkevich equations were used to fit the experimental data. The best theoretical isotherm of Langmuir, Freundlich, or/and Dubinin–Radushkevich for arsenic bio-adsorption by Chlorella vulgaris was determined. To choose the best theoretical isotherm, the coefficient of correlation was used. The data on absorption appeared to be linearly consistent with the Langmuir (qmax = 45 mgg−1; R2 = 0.9894), Freundlich (kf = 1.44; R2 = 0.7227), and Dubinin–Radushkevich (qD–R = 8.7 mg/g; R2 = 0.951) isotherms. The Langmuir and Dubinin–Radushkevich isotherms were both good two-parameter isotherms. In general, Langmuir was demonstrated to be the most accurate model for As (III) bio-adsorption on the bio-adsorbent. Maximum bio-adsorption values and a good correlation coefficient were observed for the first-order kinetic model, indicating that it was the best fitting model and significant in describing the arsenic (III) adsorption process. SEM micrographs of treated and untreated algal cells revealed that ions adsorbed on the algal cell’s surface. A Fourier-transform infrared spectrophotometer (FTIR) was used to analyze the functional groups in algal cells, such as the carboxyl group, hydroxyl, amines, and amides, which aided in the bio-adsorption process. Thus, C. vulgaris has great potential and can be found in eco-friendly biomaterials capable of adsorbing arsenic contaminants from water sources.

3D-Printed MOFs/Polymer Composite as a Separatable Adsorbent for the Removal of Phenylarsenic Acid in the Aqueous Solution

“…The adsorption isotherm under given conditions represents the equilibrium relationship between the concentration of adsorbate in the phenylarsenic acid solution and the concentration of adsorbate indicated by the adsorbent . In the present study, a series of equilibrium adsorption experiments have been carried out at 25, 35, and 45 °C conditions.…”

“…The adsorption isotherm under given conditions represents the equilibrium relationship between the concentration of adsorbate in the phenylarsenic acid solution and the concentration of adsorbate indicated by the adsorbent. 68 In the present study, a series of equilibrium adsorption experiments have been carried out at 25, 35, and 45 °C conditions. As shown in Figure 5, Langmuir (eq 5), Freundlich (eq 6), Temkin (eq 7), and Dubinin− Radushkevich models (eq 8) have been used to fit the experimental equilibrium data, while relevant fitting parameters have been calculated according to the respective isotherm equations in Table 2.…”